Owner's Manual

GB22
SAFETY HANDLING
Your airgun has an automatic locking safety
which engages automatically when you
cock your gun. The safety slide is situated
at the end of the compression tube (fig. C):
● Back = safe
Safety button fully rearward - white dot
visible - the safety is in the “ON” or “Safe”
position
● Forward = fire
Push the safety button fully forward - whi-
te dot not visible - to put the safety in the
“OFF” or “Fire” position.
ADJUSTING THE TRIGGER
Trigger pull is adjusted in the factory, and
does not need adjustment for most shooters.
This two stage trigger has an adjusting
screw for second stage length adjustment
(fig. N).
This feature is for experienced shooters
on models X10, X20, X20 Suppressor,
Atac, Atac Suppressor and X50.
● To reduce second stage length, turn
screw clockwise.
● To increase second stage length, turn
screw counter clockwise.
COCKING
Point the airgun in safe direction while keep-
ing your finger off the trigger (fig. Q).
With one hand grasp stock at the pistol
grip. Holding the rifle firmly, tap barrel
behind front sight in order to break locked
position (fig. R).
Grasp barrel behind the front sight and pull
downward until it stops.You will hear an audi-
ble click of the trigger mechanism lock when
the pressure is released. You must control,
and not release, the barrel under strong
resistance until the audible click is heard.
Be careful not to pinch your hand or fingers
in the hinge area (fig. S).
LOADING
Check pellet to ensure it matches the cali-
ber of the airgun. Insert pellet into the bar-
rel until skirt is flush with breech face (fig.
T).
Move barrel back to its original locked posi-
tion.
Again, be careful not to pinch your hand or
fingers in the hinge area (fig. U).
SHOOTING: AIMING AND
FIRING
Keep finger outside trigger guard until on
target, push safety button fully forward,
squeeze trigger. Safety can be put back to
“On” or “Safe” positions at any time by pul-
ling fully rewarded (white dot visible).
A) Wrong (fig.V)
B) Right (fig. Z)
Your airgun is equipped with an adjustable
rear sight for both elevation (1) (up-down)
and windage (left-right) (2).
Elevation settings are marked on the eleva-
tion knob and controlled by turning eleva-
tion screw 1.
● Turn clockwise to make the airgun shoot
lower
● Turn counter clockwise to make the air-
gun shoot higher
Left or Right windage settings are marked
on the sliding scale and controlled by turn-
ing windage screw 2.
● Turn clockwise to make the pellet hit to the
right
● Turn counter clockwise to make the pellet
hit to the left
The scale and numbers are for reference
only, and do not represent a specific distan-
ce at the target.
2
3
4
5
6
UM X5-X10-X20-X50(cal.22-35) 21-12-2012 14:30 Pagina 22