Manual

8. Grasp toggle mechanism with left thumb and

forefinger and lift up gently. IMPORTANT

the

spring-activated takedown plunger (J) can fly free

as the inner mechanism clears the frame be sure

to cup your right hand over this area to catch the

plunger and spring.

DO NOT DISASSEMBLE FURTHER: the above-

described field stripping procedure renders all

surfaces available to cleaning and lubricating

no further take-down is necessary.

ASSEMBLING THE LUGER:

1. Insert takedown plunger and spring (J) in rear of

boltways block assembly (K).

2. Hold gun in right hand so that the right thumb

can depress the magazine catch (A). With the

left hand grasp the firing assembly between the

left thumb and middle finger so that the palm

of the left hand is laying over the top of the

toggles. Insert this unit into the frame by slid-

ing the magazine guide (M) into the grip well.

When the takedown plunger (J) nears the re-

ceiver, position the lower half of the takedown

plunger button against the inner top surface of

the rear receiver wall. By applying pressure with

the left hand it is possible to compress the

takedown plunger (J) against its spring and a

slight downward slap, with the palm of the hand,

will seat the entire firing apparatus. When prop-

erly seated the takedown plunger should extend

into its recess in the rear wall of the frame.

3. Move trigger slightly rearward and press down

lighty on the sear bar (L). The sear bar must

(Continned on following page)