Manual
cri ption
Quant.
P. N.o Code N.o
Description
Quant.
:er Guard Screw
I
79
HL-12-379
Trigger Guard
I
Imer Activactor
Guide
2
81
HL-12-38 I
Trigger Spring
I
Imer
Imp. Spring Limiter Nut
2
lIizer Impeller Pin
I
HL-12-400
Stock Assembly
lIizer
Imp. and Trigger Spring
I
85
HL-12-48s
Wood Stock
I
:er
I
86
HL-12-486
Stock Bolt Washer
I
lIizer
I
87
HL-12-487
Stock Bolt
I
ty Catch
I
90
HL-12-490
Butt
Plate Spacer
I
2
94
HL-12-494
Recoil
Pad
I
ty Activating Spring Screw
I
95
HL-12-49s
Butt Plate Screws
2
lIizer Fastening Pin
I
CONDOR
OVER
AND UNDER SHOTGUN
TO
ASSEMBLE GUN
-
Your shotgun is shipped from the factory with
barrel assembly and forearm assembly removed from gun. Before
assembling, remove forearm and clean lubrication from metal parts and
barrel bores. Rotate top lock lever to right (counter-clockwise) to cam top
lock open. Carefully fit barrel assembly into frame. Fit the two small circu-
lar cuts on underside of barrel assembly to pivot pins protruding form inside
of frame. Hold this engagement and rotate barrel assembly upward until
action is closed and top lock latches into place. Carefully place forearm
assembly over bottom barrel it a slight angle. Adjust to fit radius on forearm
iron to matching radius on front of frame. Press forearm assembly upward
to latch into place. Please notice that-the lever is slightly loose. This
looseness will disappear as the gun adjust with use.
SAFETY
-
The gun has an automatic safety. By opening the gun for loading
or unloading, automaticaly the safety button moves to the
"S"
pOSItIOn
which inicates that the gun is locked. If on your gun the safety IS mechanic.
push the button to the
"S"
position.
TO LOAD
-
CAUTION
-
Before loading, make sure barrel bores are
clean and free of any grease, heavy oil, snow or other obstruction. With
safety selector on safe position, rotate top lock lever to right to unlatch top
lock. Rotate barrel assembly downward to break (open) action Place shells
into barrel chambers and close and lock action, if required.
TO UNLOAD
-
Rotate top lock lever to right and open action Shells will
be automatically extracted from gun and may be removed by hand. or
ejected (if the case).
TO REMOVE FOREARM IRON ASSEMBLY
-
Remove forearm assembly
Unscrew front forearm screw and rear forearm screw. Pull Iron from
forearm. Slide forearm iron assembly from forearm. Assemble In reverse
TO
REMOVE FOREARM ASSEMBLY
-
Press forearm latch forward Push
front of forearm assembly downward.
\~
TO
REMOVE BARREL ASSEMBLY
-
Remove forearm assembly.
Open
action. Move barrel assembly downward slightly to disengage from pivOt
pins. Lift upward and remove from frame.
TO
REASSEMBLE
STOCK
-
If stock has been removed, take special care
in reassembly. The stock bolt should be tightened, to torque not exceeding
5 ft. Ibs. Overtightening of stock bolt mav adversely affect proper functioning
of gun.