Datasheet
Table Of Contents
- Table 1. Device summary
- 1 Block diagram and pin description
- 2 Electrical specifications
- 2.1 Absolute maximum rating
- 2.2 Electrical characteristics
- Table 4. Power off
- Table 5. Power on
- Table 6. Dynamic
- Table 7. Gate resistance
- Table 8. Source drain diode
- Table 9. Switching on HSD
- Table 10. Switching on LSD
- Table 11. Switching off HSD
- Table 12. Switching off LSD
- Table 13. Thermal sensor
- Figure 4. Gate charge vs gate-source voltage HS
- Figure 5. Gate charge vs gate-source voltage LS
- Figure 6. Capacitance variations HS
- Figure 7. Capacitance variations LS
- Figure 8. Thermal sensor voltage vs temperature
- Figure 9. Gate charge test circuit
- Figure 10. Test circuit for inductive load switching and diode recovery times
- Figure 11. Switching times test circuit for resistive load
- 3 Package and PCB thermal data
- 3.1 PowerSSO-36 thermal data
- Figure 12. PowerSSO-36 PC board
- Figure 13. Chipset configuration
- Figure 14. Auto and mutual Rthj-amb vs PCB copper area in open box free air condition
- 3.1.1 Thermal calculation in clockwise and anti-clockwise operation in steady-state mode
- 3.1.2 Thermal resistances definition (values according to the PCB heatsink area)
- 3.1.3 Thermal calculation in transient mode
- 3.1.4 Single pulse thermal impedance definition (values according to the PCB heatsink area)
- 3.1 PowerSSO-36 thermal data
- 4 Package and packing information
- 5 Revision history
Package and packing information VNH7013XP-E
22/24 Doc ID 022370 Rev 3
4.3 PowerSSO-36 TP packing information
Figure 19. PowerSSO-36 TP tube shipment (no suffix)
Figure 20. PowerSSO-36 TP tape and reel shipment (suffix “TR”)
All dimensions are in mm.
Base Qty 49
Bulk Qty 1225
Tube length (±0.5) 532
A 3.5
B 13.8
C (±0.1) 0.6
A
C
B
Base Qty 1000
Bulk Qty 1000
A (max) 330
B (min) 1.5
C (±0.2) 13
F 20.2
G (+2 / -0) 24.4
N (min) 100
T (max) 30.4
Reel dimensions
Tape dimensions
According to Electronic Industries Association
(EIA) Standard 481 rev. A, Feb. 1986
All dimensions are in mm.
Tape width W 24
Tape Hole Spacing P0 (±0.1) 4
Component Spacing P 12
Hole Diameter D (±0.05) 1.55
Hole Diameter D1 (min) 1.5
Hole Position F (±0.1) 11.5
Compartment Depth K (max) 2.85
Hole Spacing P1 (±0.1) 2
Top
cover
tape
End
Start
No componentsNo components Components
500mm min
500mm min
Empty components pockets
sealed with cover tape.
User direction of feed