Datasheet
Table Of Contents
- Table 1. Device summary
- 1 Block diagram and pin description
- 2 Electrical specifications
- 2.1 Absolute maximum rating
- 2.2 Electrical characteristics
- Table 4. Power off
- Table 5. Power on
- Table 6. Dynamic
- Table 7. Gate resistance
- Table 8. Source drain diode
- Table 9. Switching on HSD
- Table 10. Switching on LSD
- Table 11. Switching off HSD
- Table 12. Switching off LSD
- Table 13. Thermal sensor
- Figure 4. Gate charge vs gate-source voltage HS
- Figure 5. Gate charge vs gate-source voltage LS
- Figure 6. Capacitance variations HS
- Figure 7. Capacitance variations LS
- Figure 8. Thermal sensor voltage vs temperature
- Figure 9. Gate charge test circuit
- Figure 10. Test circuit for inductive load switching and diode recovery times
- Figure 11. Switching times test circuit for resistive load
- 3 Package and PCB thermal data
- 3.1 PowerSSO-36 thermal data
- Figure 12. PowerSSO-36 PC board
- Figure 13. Chipset configuration
- Figure 14. Auto and mutual Rthj-amb vs PCB copper area in open box free air condition
- 3.1.1 Thermal calculation in clockwise and anti-clockwise operation in steady-state mode
- 3.1.2 Thermal resistances definition (values according to the PCB heatsink area)
- 3.1.3 Thermal calculation in transient mode
- 3.1.4 Single pulse thermal impedance definition (values according to the PCB heatsink area)
- 3.1 PowerSSO-36 thermal data
- 4 Package and packing information
- 5 Revision history
Package and packing information VNH7013XP-E
20/24 Doc ID 022370 Rev 3
4 Package and packing information
4.1 ECOPACK
®
packages
In order to meet environmental requirements, ST offers these devices in different grades of
ECOPACK
®
packages, depending on their level of environmental compliance. ECOPACK
®
specifications, grade definitions and product status are available at: www.st.com
.
ECOPACK
®
is an ST trademark.
4.2 PowerSSO-36 TP package information
Figure 18. PowerSSO-36 TP package dimensions