Datasheet
Absolute maximum ratings and operating conditions TS922, TS922A
4/24 DocID5150 Rev 11
2 Absolute maximum ratings and operating conditions
Table 1. Absolute maximum ratings (AMR)
Symbol Parameter Value Unit
V
CC
Supply voltage
(1)
1. All voltage values, except differential voltage are with respect to network ground terminal.
14
VV
id
Differential input voltage
(2)
2. The differential voltage is the non-inverting input terminal with respect to the inverting input terminal. If
V
id
> ±1 V, the maximum input current must not exceed ±1 mA. In this case (V
id
> ±1 V), an input series
resistor must be added to limit the input current.
±1
V
in
Input voltage
(3)
3. Do not exceed 14 V.
V
CC-
-0.3 to V
CC+
+0.3
T
stg
Storage temperature -65 to +150 °C
R
thja
Thermal resistance junction to ambient
(4)
Flip-chip
SO8
TSSOP8
4. Short-circuits can cause excessive heating. Destructive dissipation can result from simultaneous short-
circuits on all amplifiers. These values are typical.
90
125
120
°C/W
R
thjc
Thermal resistance junction to case
(4)
SO8
TSSOP8
40
37
T
j
Maximum junction temperature 150 °C
ESD
HBM: human body model
(5)
MM: machine model
(6)
CDM: charged device model
(7)
5. Human body model: 100 pF discharged through a 1.5 kΩ resistor between two pins of the device, done for
all couples of pin combinations with other pins floating.
6. Machine model: a 200 pF capacitor is charged to the specified voltage, then discharged directly between
two pins of the device with no external series resistor (internal resistor < 5 Ω). This is done for all couples of
pin combinations with other pins floating.
7. Charged device model: all pins and plus package are charged together to the specified voltage and then
discharged directly to ground.
2000
120
1500
V
Output short-circuit duration See note
(8)
8. There is no short-circuit protection inside the device: short-circuits from the output to V
CC
can cause
excessive heating. The maximum output current is approximately 80 mA, independent of the magnitude of
V
CC
. Destructive dissipation can result from simultaneous short-circuits on all amplifiers.
Latch-up immunity 200 mA
Soldering temperature (10 s), leaded version
Soldering temperature (10 s), unleaded version
250
260
°C