Datasheet

DocID15718 Rev 4 3/16
TS9222, TS9224 Absolute maximum ratings and operating conditions
16
1 Absolute maximum ratings and operating conditions
Table 1. Absolute maximum ratings (AMR)
Symbol Parameter Value Unit
V
CC
Supply voltage
(1)
1. All voltage values, except differential voltage are with respect to network ground terminal.
14
VV
id
Differential input voltage
(2)
2. Differential voltages are the non-inverting input terminal with respect to the inverting input terminal. If
V
id
> ±1 V, the maximum input current must not exceed ±1 mA. In this case (V
id
> ±1 V), an input series
resistor must be added to limit input current.
±1
V
in
Input voltage
(3)
3. Do not exceed 14 V.
V
CC-
-0.3 to V
CC+
+0.3
T
stg
Storage temperature -65 to +150 °C
R
thja
Thermal resistance junction to ambient
(4)
SO8
TSSOP8
SO14
TSSOP14
4. Short-circuits can cause excessive heating. Destructive dissipation can result from simultaneous short-
circuits on all amplifiers. These values are typical.
125
120
66
100
°C/W
T
j
Maximum junction temperature 150 °C
ESD
TS9222
HBM: human body model
(5)
5. Human body model: a 100 pF capacitor is charged to the specified voltage, then discharged through a
1.5kΩ resistor between two pins of the device. This is done for all couples of connected pin combinations
while the other pins are floating.
2000
VMM: machine model
(6)
6. Machine model: a 200 pF capacitor is charged to the specified voltage, then discharged directly between
two pins of the device with no external series resistor (internal resistor < 5 Ω). This is done for all couples of
connected pin combinations while the other pins are floating.
120
CDM: charged device model
(7)
7. Charged device model: all pins and the package are charged together to the specified voltage and then
discharged directly to the ground through only one pin. This is done for all pins.
1500
ESD
TS9224
HBM: human body model
(5)
3kV
MM: machine model
(6)
100 V
CDM: charged device model
(7)
SO14
TSSOP14
1.5
1
kV
Output short circuit duration see note
(8)
8. There is no short-circuit protection inside the device: short-circuits from the output to V
CC
can cause
excessive heating. The maximum output current is approximately 80mA, independent of the magnitude of
V
CC
. Destructive dissipation can result from simultaneous short-circuits on all amplifiers.
Latch-up immunity 200 mA
Soldering temperature (10 sec), unleaded version 260 °C