Datasheet

TS4962 Application overview
Doc ID 10968 Rev 8 5/44
2 Application overview
Table 4. External component information
Component Functional description
C
S
Bypass supply capacitor. Install as close as possible to the TS4962 to
minimize high-frequency ripple. A 100 nF ceramic capacitor should be added
to enhance the power supply filtering at high frequencies.
R
in
Input resistor used to program the TS4962’s differential gain
(gain = 300 kΩ/R
in
with R
in
in kΩ).
Input capacitor
Because of common-mode feedback, these input capacitors are optional.
However, they can be added to form with R
in
a 1st order high-pass filter with
-3 dB cut-off frequency = 1/(2*
π*R
in
*C
in
).
Table 5. Pin description
Pin number Pin name Description
1 STBY Standby input pin (active low)
2 NC No internal connection pin
3 IN+ Positive input pin
4 IN- Negative input pin
5 OUT+ Positive output pin
6 VCC Power supply input pin
7 GND Ground input pin
8 OUT- Negative output pin
Exposed pad
Exposed pad can be connected to ground (pin 7) or left
floating