Datasheet

ManualsBrandsSTMICROELECTRONICS ManualsLinear ICsLinear IC - Comparator Multi-purpose CMOS, Open drain SO 14

This is information on a product in full production.

September 2012 Doc ID 4065 Rev 3 1/11

TS339

Micropower quad CMOS voltage comparator

Datasheet − production data

Features

■ Extremely low supply current: 9 μA typ./comp.

■ Wide single supply range 2.7 V to 16 V or dual

supplies (±1.35 V to ±8 V)

■ Extremely low input bias current: 1 pA typ.

■ Extremely low input offset current: 1 pA typ.

■ Input common-mode voltage range includes

GND

■ High input impedance: 10

Ω typ.

■ Fast response time: 1.5 ms typ. for 5 mV

overdrive

■ Pin-to-pin and functionally compatible with

bipolar LM339 device

Description

The TS339 device is a micropower CMOS quad

voltage comparator with extremely low

consumption of 9 μA typ. / comparator (20 times

less than bipolar LM339). Similar performances

are offered by the quad micropower comparator

TS3704 with a push-pull CMOS output.

Thus response times remain similar to the LM339

device.

Figure 1. Pin connection (top view)

DIP14

(plastic package)

SO14

(plastic micropackage)

TSSOP14

(thin shrink small outline package)

)NVERTINGINPUT

/UTPUT



.ONINVERTINGINPUT



/UTPUT



)NVERTINGINPUT

.ONINVERTINGINPUT 

































/UTPUT

/UTPUT



.ONINVERTINGINPUT 

)NVERTINGINPUT 

.ONINVERTINGINPUT 

)NVERTINGINPUT



















Table 1. Device summary

Order code Temperature range Package Packaging Marking

TS339CN

0 °C, +70 °C

DIP14 Tube TS339CN

TS339CD/CDT SO14 Tube or tape and reel S339C

TS339IN -40 °C, +125 °C DIP14 Tube TS339IN

TS339ID/IDT SO14 Tube or tape and reel S339I

TS339IPT

TSSOP14

(thin shrink outline package)

Tape and reel S339I

www.st.com

Summary of content (11 pages)

PAGE 1
TS339 Micropower quad CMOS voltage comparator Datasheet − production data Features ■ Extremely low supply current: 9 μA typ./comp. ■ Wide single supply range 2.7 V to 16 V or dual supplies (±1.35 V to ±8 V) ■ Extremely low input bias current: 1 pA typ. ■ Extremely low input offset current: 1 pA typ. ■ Input common-mode voltage range includes GND ■ High input impedance: 1012 Ω typ. ■ Fast response time: 1.5 ms typ.
PAGE 2
Absolute maximum ratings 1 TS339 Absolute maximum ratings Table 2.
PAGE 3
TS339 Typical application schematics 2 Typical application schematics Figure 2.
PAGE 4
Electrical characteristics TS339 3 Electrical characteristics Table 3. VCC+ = 3 V, VCC- = 0 V, Tamb = 25 °C (unless otherwise specified) Symbol Parameter Min. Typ. Vio Input offset voltage(1) Vic = 1.5 V Tmin. ≤ Tamb ≤ Tmax. Iio Input offset current(2) Vic = 1.5 V Tmin. ≤ Tamb ≤ Tmax. 1 Input bias current (2) Vic = 1.5 V Tmin. ≤ Tamb ≤ Tmax. 1 Iib Max. Unit 5 6.5 mV pA 300 pA 600 VCC+-1.2 VCC+ -1.5 Vicm Input common mode voltage range Tmin.
PAGE 5
TS339 Table 4. Electrical characteristics VCC+ = 5 V, VCC- = 0 V, Tamb = 25 °C (unless otherwise specified) Symbol Parameter Min. Typ. Max. Unit 1.4 5 6.5 mV Vio Input offset voltage(1) Vic = 2.5 V, Vcc+ = 5 V to 10 V Tmin. ≤ Tamb ≤ Tmax. Iio Input offset current(2) Vic = 2.5 V Tmin. ≤ Tamb ≤ Tmax. 1 Input bias current(2) Vic = 2.5 V Tmin. ≤ Tamb ≤ Tmax. 1 Iib pA 300 pA 600 VCC+-1.2 VCC+ -1.5 Vicm Input common mode voltage range Tmin.
PAGE 6
Package information 4 TS339 Package information In order to meet environmental requirements, ST offers these devices in different grades of ECOPACK® packages, depending on their level of environmental compliance. ECOPACK specifications, grade definitions and product status are available at: www.st.com. ECOPACK is an ST trademark.
PAGE 7
TS339 4.1 Package information DIP14 package Figure 3. DIP14 package outline Table 5. DIP-14 package mechanical data Dimensions Symbol mm Min. a1 0.51 B 1.39 Typ. inch Max. Min. Typ. Max. 0.020 1.65 0.055 0.065 b 0.5 0.020 b1 0.25 0.010 D 20 0.787 E 8.5 0.335 e 2.54 0.100 e3 15.24 0.600 F 7.1 0.280 I 5.1 0.201 L Z 3.3 1.27 0.130 2.54 Doc ID 4065 Rev 3 0.050 0.
PAGE 8
Package information 4.2 TS339 SO14 package Figure 4. SO14 package outline Table 6. SO14 package mechanical data Dimensions Symbol mm Min. Typ. A a1 inch Max. Typ. 1.75 0.1 0.2 a2 Max. 0.068 0.003 0.007 1.65 0.064 b 0.35 0.46 0.013 0.018 b1 0.19 0.25 0.007 0.010 C 0.5 0.019 c1 45° (typ.) D 8.55 8.75 0.336 0.344 E 5.8 6.2 0.228 0.244 e 1.27 0.050 e3 7.62 0.300 F 3.8 4.0 0.149 0.157 G 4.6 5.3 0.181 0.208 L 0.5 1.27 0.019 0.050 M 0.
PAGE 9
TS339 4.3 Package information TSSOP14 package Figure 5. TSSOP14 package outline ! ! ! B E + C , % $ % 0). )$%.4)&)#!4)/. $ Table 7. TSSOP14 package mechanical data Dimensions Symbol mm. Min. Typ. A inch Max. Min. Typ. 1.2 A1 0.05 A2 0.8 b Max. 0.047 0.15 0.002 0.004 0.006 1.05 0.031 0.039 0.041 0.19 0.30 0.007 0.012 c 0.09 0.20 0.004 0.0089 D 4.9 5 5.1 0.193 0.197 0.201 E 6.2 6.4 6.6 0.244 0.252 0.260 E1 4.3 4.4 4.48 0.169 0.
PAGE 10
Revision history TS339 5 Revision history Table 8. Document revision history Date Revision Jan. 2003 1 Initial release. Aug. 2005 2 1 - PPAP references inserted in the datasheet see Table 1: Order codes on page 1. 2 - ESD protection inserted in Table 2 Key parameters and their absolute maximum ratings on page 2. 3 Updated Features, Table 1, removed TS339IYD and TS339IYDT from Table 1. Updated ECOPACK text, reformatted Section 4: Package information. Minor corrections throughout document.
PAGE 11
TS339 Please Read Carefully: Information in this document is provided solely in connection with ST products. STMicroelectronics NV and its subsidiaries (“ST”) reserve the right to make changes, corrections, modifications or improvements, to this document, and the products and services described herein at any time, without notice. All ST products are sold pursuant to ST’s terms and conditions of sale.