Datasheet
Table Of Contents
- 1 Schematic diagram
- 2 Absolute maximum ratings and operating conditions
- 3 Electrical characteristics
- Table 3. VCC = ±15 V, Tamb = +25 °C (unless otherwise specified)
- Figure 2. Maximum peak-to-peak output voltage versus frequency
- Figure 3. Maximum peak-to-peak output voltage versus frequency
- Figure 4. Maximum peak-to-peak output voltage versus frequency
- Figure 5. Maximum peak-to-peak output voltage versus free air temperature
- Figure 6. Maximum peak-to-peak output voltage versus load resistance
- Figure 7. Maximum peak-to-peak output voltage versus supply voltage
- Figure 8. Input bias current versus free air temperature
- Figure 9. Large signal differential voltage amplification versus free air temperature
- Figure 10. Large signal differential voltage amplification and phase shift versus frequency
- Figure 11. Total power dissipation versus free air temperature
- Figure 12. Supply current per amplifier versus free air temperature
- Figure 13. Common mode rejection ratio versus free air temperature
- Figure 14. Voltage follower large signal pulse response
- Figure 15. Output voltage versus elapsed time
- Figure 16. Equivalent input noise voltage versus frequency
- Figure 17. Total harmonic distortion versus frequency
- 4 Parameter measurement information
- 5 Typical applications
- 6 Package information
- 7 Ordering information
- 8 Revision history
DocID2297 Rev 5 13/18
TL074 Package information
18
6 Package information
In order to meet environmental requirements, ST offers these devices in different grades of
ECOPACK® packages, depending on their level of environmental compliance. ECOPACK®
specifications, grade definitions and product status are available at: www.st.com.
ECOPACK is an ST trademark.