Datasheet
Table Of Contents
- 1 Schematic diagram
- 2 Absolute maximum ratings and operating conditions
- 3 Electrical characteristics
- Table 3. VCC = ±15 V, Tamb = +25 °C (unless otherwise specified)
- Figure 2. Maximum peak-to-peak output voltage versus frequency
- Figure 3. Maximum peak-to-peak output voltage versus frequency
- Figure 4. Maximum peak-to-peak output voltage versus frequency
- Figure 5. Maximum peak-to-peak output voltage versus free air temperature
- Figure 6. Maximum peak-to-peak output voltage versus load resistance
- Figure 7. Maximum peak-to-peak output voltage versus supply voltage
- Figure 8. Input bias current versus free air temperature
- Figure 9. Large signal differential voltage amplification versus free air temperature
- Figure 10. Large signal differential voltage amplification and phase shift versus frequency
- Figure 11. Total power dissipation versus free air temperature
- Figure 12. Supply current per amplifier versus free air temperature
- Figure 13. Common mode rejection ratio versus free air temperature
- Figure 14. Voltage follower large signal pulse response
- Figure 15. Output voltage versus elapsed time
- Figure 16. Equivalent input noise voltage versus frequency
- Figure 17. Total harmonic distortion versus frequency
- 4 Parameter measurement information
- 5 Typical applications
- 6 Package information
- 7 Ordering information
- 8 Revision history

This is information on a product in full production.
November 2013 DocID2297 Rev 5 1/18
TL074
Low-noise JFET quad operational amplifier
Datasheet - production data
Features
• Wide common-mode (up to V
CC
+
) and
differential voltage range
• Low input bias and offset current
• Low noise e
n
= 15 nV/ √ Hz (typ)
• Output short-circuit protection
• High input impedance JFET input stage
• Low harmonic distortion: 0.01% (typical)
• Internal frequency compensation
• Latch up free operation
• High slew rate: 16 V/µs (typical)
Related products
• See TL071 for single version
• See TL072 for dual version
Description
The TL074, TL074A, and TL074B are high-speed
JFET input single operational amplifiers. Each of
these JFET input operational amplifiers
incorporates well matched, high-voltage JFET
and bipolar transistors in a monolithic integrated
circuit.
The devices feature high slew rates, low input
bias and offset currents, and low offset voltage
temperature coefficient.
Inverting Input 2
Non-inverting Input 2
Non-inverting Input 1
CC
V
-
CC
V
1
2
3
4
8
5
6
7
9
10
11
12
13
14
+
Output 3
Output 4
Non-inverting Input 4
Inverting Input 4
Non-inverting Input 3
Inverting Input 3
-
+
-
+
-
+
-
+
Output 1
Inverting Input 1
Output 2
D
SO14
(plastic micropackage)
Pin connections
(top view)
www.st.com