Datasheet

ManualsBrandsSTMICROELECTRONICS ManualsThyristors & TriacsTYN 825 Thyristor

November 2008 Rev 1 1/11

P010xx

Sensitive standard SCRs up to 0.8 A

Features

■ I

T(RMS)

up to 0.8 A

■ V

DRM

RRM

100, 200, 400 and 600 V

■ I

from 5 to 200 µA

Description

Thanks to highly sensitive triggering levels, the

P010xx SCR series is suitable for all applications

where available gate current is limited, such as

ground fault circuit interruptors, pilot circuits in

solid state relays, stand-by mode power supplies,

smoke and alarm detectors.

Available in through-hole or surface mount

packages, the voltage capability of this series has

been upgraded since its introduction and is now

available up to 600 V.

TO-92

(P010xxA)

SOT-223

(P0102xN)

SOT23-3L

(P010xxL)

Table 1. Device summary

Order code

Voltage

Sensitivity Package

Packing

Mode

100 V 200 V 400 V 600 V

P0102AA 1AA3 X 200 µA TO-92 Bulk

P0102AA 5AL3 X 200 µA TO-92 Tape and reel 13 inch

P0102AL 5AA4 X 200 µA SOT23-3L Tape and reel 7 inch

P0102BA 1AA3 X 200 µA TO-92 Bulk

P0102BL 5AA4 X 200 µA SOT23-3L Tape and reel 7 inch

P0102DA 1AA3 X 200 µA TO-92 Bulk

P0102DA 2AL3 X 200 µA TO-92 Ammopack

P0102DA 5AL3 X 200 µA TO-92 Tape and reel 13 inch

P0102DN 5AA4 X X 200 µA SOT-223 Tape and reel 7 inch

P0102MA 1AA3 X 200 µA TO-92 Bulk

P0102MN 5AA4 X 200 µA SOT-223 Tape and reel 7 inch

P0109AL 5AA4 X 1 µA SOT23-3L Tape and reel 7 inch

P0109DA 1AA3 X 1 µA TO-92 Bulk

P0109DA 5AL3 X 1 µA TO-92 Tape and reel 13 inch

www.st.com

Summary of content (11 pages)

PAGE 1
P010xx Sensitive standard SCRs up to 0.8 A Features A ■ IT(RMS) up to 0.8 A ■ VDRM/VRRM100, 200, 400 and 600 V ■ IGTfrom 5 to 200 µA G A K KA Description K Thanks to highly sensitive triggering levels, the P010xx SCR series is suitable for all applications where available gate current is limited, such as ground fault circuit interruptors, pilot circuits in solid state relays, stand-by mode power supplies, smoke and alarm detectors.
PAGE 2
Characteristics P010xx 1 Characteristics Table 2. Absolute ratings (limiting values) P010xxA and P010xxN Symbol IT(RMS) Parameter IT(AV) Average on-state current (180° conduction angle) ITSM Non repetitive surge peak on-state current I ²t TO-92 Tl = 55 °C SOT-223 Tamb = 70 °C TO-92 Tl = 55 °C SOT-223 Tamb = 70 °C RMS on-state current (180° conduction angle) tp = 8.3 ms tp = 10 ms Value Unit 0.8 A 0.5 A 8 Tj = 25 °C A 7 I²t Value for fusing tp = 10 ms Tj = 25 °C 0.
PAGE 3
P010xx Table 4. Characteristics Electrical characteristics(1) P010xxA and P010xxN Symbol IGT Test conditions VD = 12 V Value Unit Min. - Max. 200 Max. 0.8 V Min. 0.1 V Min. 8 V µA RL = 140 Ω VGT VGD VD = VDRM RL = 3.3 kΩ RGK = 1 kΩ VRG IRG = 10 µA IH IT = 50 mA RGK = 1 kΩ Max. 5 mA IL IG = 1 mA RGK = 1 kΩ Max. 6 mA Tj = 125 °C Min. 75 V/µs Tj = 25 °C Max. 1.95 V Tj = 125 °C dV/dt VD = 67 % VDRM VTM ITM = 1.6 A Vt0 Threshold voltage Tj = 125 °C Max. 0.
PAGE 4
Characteristics Table 6. P010xx Thermal resistance Symbol Parameter Maximum Unit TO-92 80 °C/W SOT-223 30 °C/W TO-92 150 SOT-223 60 Rth(j-a) Junction to case (DC) Rth(j-t) Junction to tab (DC) Rth(j-a) Junction to ambient (DC) Rth(j-a) Junction to ambient (mounted on FR4 with recommended pad layout) SOT23-3L °C/W S(1) = 5 cm2 400 °C/W 1. S = Copper surface under tab. Figure 1. Maximum average power dissipation vs. average on-state current P010xxA and P010xxN Figure 2.
PAGE 5
P010xx Characteristics Figure 5. Average and DC on-state current vs. case temperature P010xxL Figure 6. IT(AV)(A) Relative variation of thermal impedance junction to ambient vs. pulse duration K=[Zth(j-a)/Rth(j-a)] 0.30 1.00 0.25 D.C. SOT23-3L 0.20 α = 180° TO-92 0.15 0.10 SOT-223 0.10 0.05 tp(s) Tcase(°C) 0.00 0.01 0 25 Figure 7. 50 75 100 125 Relative variation of gate trigger, holding, and latching currents vs. junction temperature 1E-2 1E+0 1E-1 Figure 8.
PAGE 6
Characteristics P010xx Figure 11. Surge peak on-state current versus Figure 12. Non-repetitive surge peak number of cycles on-state current and corresponding value of I²t ITSM(A), I2t (A2s) ITSM(A) 100.0 8 Tj initial = 25°C 7 ITSM tp=10ms 6 One cycle 10.0 5 Non repetitive Tj initial=25°C 4 3 For a sinusoidal pulse with width tp < 10 ms Repetitive Tamb=25°C 1.0 2 I2t 1 tp(ms) Number of cycles 0 1 10 0.1 100 1000 Figure 13. On-state characteristics P010xxA, P010xxN 0.01 10.00 1.
PAGE 7
P010xx 2 Ordering information scheme Ordering information scheme Figure 17. Ordering information scheme P 01 0x x x Blank xAxx Sensitive SCR series Current 01 up to 0.
PAGE 8
Package information P010xx Table 8. SOT-223 Dimensions Dimensions Ref. V A A1 c B B1 4 E 2 Typ. 0.60 0.70 Max. 0.071 0.001 0.80 0.024 0.027 0.031 2.90 3.00 3.10 0.114 0.118 0.122 0.24 0.26 0.32 0.009 0.010 0.013 D 6.30 6.50 6.70 0.248 0.256 0.264 2.3 0.090 4.6 0.181 E 3.30 3.50 3.70 0.130 0.138 0.146 H 6.70 7.00 7.30 0.264 0.276 0.287 10° max Figure 18. Footprint (dimensions in mm) 3.25 1.32 5.16 7.80 1.32 8/11 Typ. c V 2.30 Min. B1 e1 e Max. 0.
PAGE 9
P010xx Package information Table 9. SOT23-3L dimensions Dimensions Ref. Millimeters Inches A Min. Max. Min. Max. A 0.89 1.4 0.035 0.055 A1 0 0.1 0 0.004 B 0.3 0.51 0.012 0.02 c 0.085 0.18 0.003 0.007 D 2.75 3.04 0.108 0.12 e 0.85 1.05 0.033 0.041 e1 1.7 2.1 0.067 0.083 E 1.2 1.6 0.047 0.063 H 2.1 2.75 0.083 0.108 E e B D e1 S A1 L c H L S 0.6 typ. 0.35 0.65 0.024 typ. 0.014 0.026 Figure 19. Footprint (dimensions in mm) 0.95 0.61 1.26 0.
PAGE 10
Ordering information 4 Ordering information Table 10. 5 Ordering information Order code Marking Package Weight Base qty Packing mode P0102AA 1AA3 P0102 AA TO-92 0.2 g 2500 Bulk P0102AA 5AL3 P0102 AA TO-92 0.2 g 2000 Tape and reel 13 inch P0102AL 5AA4 P2A SOT23-3L 0.01 g 3000 Tape and reel 7 inch P0102BA 1AA3 P0102 BA TO-92 0.2 g 1000 Bulk P0102BL 5AA4 P2B SOT23-3L 0.01 g 3000 Tape and reel 7 inch P0102DA 1AA3 P0102 DA TO-92 0.
PAGE 11
P010xx Please Read Carefully: Information in this document is provided solely in connection with ST products. STMicroelectronics NV and its subsidiaries (“ST”) reserve the right to make changes, corrections, modifications or improvements, to this document, and the products and services described herein at any time, without notice. All ST products are sold pursuant to ST’s terms and conditions of sale.