Datasheet

Applications information TDA7498L
22/27 Doc ID 16504 Rev 3
5.6 Output low-pass filter
To avoid EMI problems, it may be necessary to use a low-pass filter before the speaker. The
cutoff frequency should be larger than 22 kHz and much lower than the output switching
frequency. It is necessary to choose the L and C component values depending on the
loudspeaker impedance. Some typical values, which give a cutoff frequency of 27 kHz, are
shown in Figure 25 and Figure 26 below.
Figure 25. Typical LC filter for a 8-Ω speaker
Figure 26. Typical LC filter for a 6-Ω speaker
(U
(U
&P
MHO
&N
MHO
&N
MHO
&N
&N
&N
MHO
0?-70
.?
-
7
0
(
U

(U
&P
MHO
&N
MHO
&N
MHO
&N
&N
&N
MHO
0
?-70
.?
-
70