Datasheet

TDA7498L Applications information
Doc ID 16504 Rev 3 21/27
5.5 Internal and external clocks
The clock of the class-D amplifier can be generated internally or can be driven by an
external source.
If two or more class-D amplifiers are used in the same system, it is recommended that all
devices operate at the same clock frequency. This can be implemented by using one
TDA7498L as master clock, while the other devices are in slave mode, that is, externally
clocked. The clock interconnect is via pin SYNCLK of each device. As explained below,
SYNCLK is an output in master mode and an input in slave mode.
5.5.1 Master mode (internal clock)
Using the internal oscillator, the output switching frequency, f
SW
, is controlled by the
resistor, R
OSC
, connected to pin ROSC:
f
SW
= 10
6
/ ((R
OSC
* 16 + 182) * 4) kHz
where R
OSC
is in kΩ.
In master mode, pin SYNCLK is used as a clock output pin whose frequency is:
f
SYNCLK
= 2 * f
SW
For master mode to operate correctly then resistor R
OSC
must be less than 60 kΩ as given
below in Tabl e 9 .
5.5.2 Slave mode (external clock)
In order to accept an external clock input the pin ROSC must be left open, that is, floating.
This forces pin SYNCLK to be internally configured as an input as given in Tabl e 9.
The output switching frequency of the slave devices is:
f
SW
= f
SYNCLK
/ 2
Figure 24. Master and slave connection
Table 9. How to set up SYNCLK
Mode ROSC SYNCLK
Master R
OSC
< 60 kΩ Output
Slave Floating (not connected) Input
SYNCLK ROSC
Rosc
Cosc
ROSC SYNCLK
39 kΩ
100 nF
Output
Input
Master Slave
TDA7498L
TDA7498L