Datasheet

STTS75 Operation
Doc ID 13298 Rev 11 11/41
2.1 Applications information
STTS75 digital temperature sensors are optimal for thermal management and thermal
protection applications. They require no external components for operations except for pull-
up resistors on SCL, SDA, and OS
/INT outputs. A 0.1 µF bypass capacitor is recommended.
The sensing device of STTS75 is the chip itself. The typical interface connection for this type
of digital sensor is shown in Figure 4 on page 11.
Intended applications include:
● System thermal management
● Computers/disk drivers
● Electronics/test equipment
● Power supply modules
● Consumer products
● Battery management
● Fax/printers management
● Automotive
Figure 4. Typical 2-wire interface connection diagram
1. SDA and OS/INT are open drain.
AI11832
Pull-up
V
DD
O.S./INT
(1)
V
DD
V
DD
Master
Device
0.1μF
STTS75
SCL
GND
SDA
(1)
Pull-up
V
DD
10kΩ
10kΩ 10kΩ
A
0
A
1
A
2
I
2
C Address = 1001000 (1001A
2
A
1
A
0
)