Datasheet

Figure 9: Pin input voltage
STM8 pin
V
IN
Absolute maximum ratings10.2
Stresses above those listed as ‘absolute maximum ratings’ may cause permanent damage
to the device. This is a stress rating only and functional operation of the device under these
conditions is not implied. Exposure to maximum rating conditions for extended periods may
affect device reliability.
Table 18: Voltage characteristics
UnitMaxMinRatingsSymbol
V
6.5-0.3
Supply voltage
(1)
V
DDx
- V
SS
6.5V
SS
- 0.3
Input voltage on true open drain pins
(2)
V
IN
V
DD
+ 0.3V
SS
- 0.3
Input voltage on any other pin
(2)
mV
50-
Variations between different power pins
|V
DDx
- V
DD
|
50-
Variations between all the different ground
pins
|V
SSx
- V
SS
|
See "Absolute
maximum ratings
(electrical sensitivity)"
Electrostatic discharge voltage
V
ESD
(1)
All power (V
DD
) and ground (V
SS
) pins must always be connected to the external power supply
(2)
I
INJ(PIN)
must never be exceeded. This is implicitly insured if V
IN
maximum is respected. If V
IN
maximum
cannot be respected, the injection current must be limited externally to the I
INJ(PIN)
value. A positive
injection is induced by V
IN
>V
DD
while a negative injection is induced by V
IN
<V
SS
. For true open-drain
pads, there is no positive injection current, and the corresponding V
IN
maximum must always be respected
Table 19: Current characteristics
Unit
Max
(1)
RatingsSymbol
mA100
Total current into V
DD
power lines (source)
(2)
I
VDD
51/116DocID15590 Rev 8
Electrical characteristicsSTM8S903K3 STM8S903F3