Datasheet

Electrical characteristics10
Parameter conditions10.1
Unless otherwise specified, all voltages are referred to V
SS
.
Minimum and maximum values10.1.1
Unless otherwise specified the minimum and maximum values are guaranteed in the worst
conditions of ambient temperature, supply voltage and frequencies by tests in production on
100 % of the devices with an ambient temperature at T
A
= 25 °C and T
A
= T
Amax
(given by
the selected temperature range).
Data based on characterization results, design simulation and/or technology characteristics
are indicated in the table footnotes and are not tested in production. Based on characterization,
the minimum and maximum values refer to sample tests and represent the mean value plus
or minus three times the standard deviation (mean ± 3 Σ).
Typical values10.1.2
Unless otherwise specified, typical data are based on T
A
= 25 °C, V
DD
= 5 V. They are given
only as design guidelines and are not tested.
Typical ADC accuracy values are determined by characterization of a batch of samples from
a standard diffusion lot over the full temperature range, where 95% of the devices have an
error less than or equal to the value indicated (mean ± 2 Σ).
Typical curves10.1.3
Unless otherwise specified, all typical curves are given only as design guidelines and are not
tested.
Typical current consumption10.1.4
For typical current consumption measurements, V
DD
, V
DDIO
and V
DDA
are connected together
in the configuration shown in the following figure.
Figure 8: Supply current measurement conditions
5 V or 3.3 V
A
V
V
V
V
V
V
DD
DDA
DDIO
SS
SSA
SSIO
55/124DocID14771 Rev 12
Electrical characteristicsSTM8S105xx