Datasheet

Electrical parameters STM8L151x2, STM8L151x3
50/112 Doc ID 018780 Rev 4
7.1.5 Pin input voltage
The input voltage measurement on a pin of the device is described in Figure 10.
Figure 10. Pin input voltage
7.2 Absolute maximum ratings
Stresses above those listed as “absolute maximum ratings” may cause permanent damage
to the device. This is a stress rating only and functional operation of the device under these
conditions is not implied. Exposure to maximum rating conditions for extended periods may
affect device reliability.
V
IN
STM8L PIN
Table 11. Voltage characteristics
Symbol Ratings Min Max Unit
V
DD
- V
SS
External supply voltage (including V
DD
,
V
DDA
, and V
DDIO
)
(1)
1. All power (V
DD
, V
DDA
, V
DDIO
) and ground (V
SS
, V
SSA
, V
SSIO
) pins must always be connected to the
external power supply.
- 0.3 4.0 V
V
IN
(2)
2. V
IN
maximum must always be respected. Refer to Table 12. for maximum allowed injected current values.
Input voltage on true open-drain pins
(PC0 and PC1)
V
SS
- 0.3 V
DD
+ 4.0
V
Input voltage on five-volt tolerant (FT)
pins (PA7 and PE0)
V
SS
- 0.3 V
DD
+ 4.0
Input voltage on 3.6 V tolerant (TT) pins V
SS
- 0.3 4.0
Input voltage on any other pin V
SS
- 0.3 4.0
V
IN
(3)
3. V
IN
maximum must always be respected. Refer to Table 12. for maximum allowed injected current values.
Input voltage on true open-drain pins
(PC0 and PC1)
V
SS
- 0.3 V
DD
+ 4.0
V
Input voltage on any other pin V
SS
- 0.3 4.0
V
ESD
Electrostatic discharge voltage
see Absolute maximum
ratings (electrical sensitivity)
on page 94