Datasheet

DocID17943 Rev 6 67/134
STM8L15xx8, STM8L15xR6 Electrical parameters
121
9.1.5 Pin input voltage
The input voltage measurement on a pin of the device is described in Figure 11.
Figure 11. Pin input voltage
9.2 Absolute maximum ratings
Stresses above those listed as “absolute maximum ratings” may cause permanent damage
to the device. This is a stress rating only and functional operation of the device under these
conditions is not implied. Exposure to maximum rating conditions for extended periods may
affect device reliability.
MS32618V1
6
).
34-,0).
Table 15. Voltage characteristics
Symbol Ratings Min Max Unit
V
DD
- V
SS
External supply voltage
(including V
DDA
)
(1)
1. All power (V
DD1
, V
DD2
, V
DD3
, V
DD4
, V
DDA
) and ground (V
SS1
, V
SS2
, V
SS3
, V
SS4
, V
SSA
) pins must always
be connected to the external power supply.
- 0.3 4.0
V
V
IN
(2)
2. V
IN
maximum must always be respected. Refer to Table 16. for maximum allowed injected current values.
Input voltage on true open-drain pins
(PC0 and PC1)
V
SS
- 0.3 V
DD
+ 4.0
Input voltage on five-volt tolerant (FT)
pins
V
SS
- 0.3 V
DD
+ 4.0
Input voltage on any other pin V
SS
- 0.3 4.0
V
ESD
Electrostatic discharge voltage
see Absolute maximum
ratings (electrical sensitivity)
on page 120