Datasheet

Electrical parameters STM8L15xx8, STM8L15xR6
112/134 DocID17943 Rev 6
In the following table, data based on characterization results, not tested in production.
In the following table, data are guaranteed by design, not tested in production.
Table 51. DAC accuracy
Symbol Parameter Conditions Typ. Max. Unit
DNL Differential non linearity
(1)
R
L
≥5kΩ, C
L
≤50 pF
DACOUT buffer ON
(2)
1.5 3
12-bit
LSB
No load
DACOUT buffer OFF
1.5 3
INL Integral non linearity
(3)
R
L
≥5kΩ, C
L
≤ 50 pF
DACOUT buffer ON
(2)
24
No load
DACOUT buffer OFF
24
Offset Offset error
(4)
R
L
≥5kΩ, C
L
≤ 50 pF
DACOUT buffer ON
(2)
±10 ±25
No load
DACOUT buffer OFF
±5 ±8
Offset1 Offset error at Code 1
(5)
DACOUT buffer OFF ±1.5 ±5
Gain error Gain error
(6)
R
L
≥5kΩ, C
L
≤ 50 pF
DACOUT buffer ON
(2)
+0.1/-0.2 +0.2/-0.5
%
No load
DACOUT buffer OFF
+0/-0.2 +0/-0.4
TUE Total unadjusted error
R
L
≥5kΩ, C
L
≤ 50 pF
DACOUT buffer ON
(2)
12 30
12-bit
LSB
No load -DACOUT buffer OFF 8 12
1. Difference between two consecutive codes - 1 LSB.
2. In 48-pin package devices the DAC2 output buffer must be kept off and no load must be applied on the DAC_OUT2 output.
3. Difference between measured value at Code i and the value at Code i on a line drawn between Code 0 and last Code 1023.
4. Difference between the value measured at Code (0x800) and the ideal value = V
REF+
/2.
5. Difference between the value measured at Code (0x001) and the ideal value.
6. Difference between the ideal slope of the transfer function and the measured slope computed from Code 0x000 and 0xFFF
when buffer is ON, and from Code giving 0.2 V and (V
DDA
-0.2) V when buffer is OFF.
Table 52. DAC output on PB4-PB5-PB6
(1)
1. 32 or 28-pin packages only. The DAC channel can be routed either on PB4, PB5 or PB6 using the routing
interface I/O switch registers.
Symbol Parameter Conditions Max Unit
R
int
Internal resistance
between DAC output and
PB4-PB5-PB6 output
2.7 V < V
DD
< 3.6 V
1.4
kΩ
2.4 V < V
DD
< 3.6 V
1.6
2.0 V < V
DD
< 3.6 V
3.2
1.8 V < V
DD
< 3.6 V
8.2