Datasheet

DocID17659 Rev 9 67/131
STM32L151x6/8/B, STM32L152x6/8/B Electrical characteristics
105
6.3.5 Wakeup time from Low power mode
The wakeup times given in the following table are measured with the MSI RC oscillator. The
clock source used to wake up the device depends on the current operating mode:
Sleep mode: the clock source is the clock that was set before entering Sleep mode
Stop mode: the clock source is the MSI oscillator in the range configured before
entering Stop mode
Standby mode: the clock source is the MSI oscillator running at 2.1 MHz
AHB
GPIOA 5 4.5 3.5 4
µA/MHz
(f
HCLK
)
GPIOB 5 4.5 3.5 4.5
GPIOC 5 4.5 3.5 4.5
GPIOD 5 4.5 3.5 4.5
GPIOE 5 4.5 3.5 4.5
GPIOH 4 4 3 3.5
CRC 1 0.5 0.5 0.5
FLASH 13 11.5 9 18.5
DMA1 12 10 8 10.5
All enabled 166 138 106 130
I
DD (RTC)
0.47
µA
I
DD (LCD)
3.1
I
DD (ADC)
(3)
1450
I
DD (DAC)
(4)
340
I
DD (COMP1)
0.16
I
DD (COMP2)
Slow mode 2
Fast mode 5
I
DD (PVD / BOR)
(5)
2.6
I
DD (IWDG)
0.25
1. Data based on differential I
DD
measurement between all peripherals OFF an one peripheral with clock enabled, in the
following conditions: f
HCLK
= 32 MHz (Range 1), f
HCLK
= 16 MHz (Range 2), f
HCLK
= 4 MHz (Range 3), f
HCLK
= 64kHz
(Low power run/sleep), f
APB1
= f
HCLK
, f
APB2
= f
HCLK
, default prescaler value for each peripheral. The CPU is in Sleep
mode in both cases. No I/O pins toggling. Not tested in production.
2. HSI oscillator is OFF for this measure.
3. Data based on a differential I
DD measurement between ADC in reset configuration and continuous ADC conversion (HSI
consumption not included).
4. Data based on a differential I
DD measurement between DAC in reset configuration and continuous DAC conversion of
V
DD/2. DAC is in buffered mode, output is left floating.
5. Including supply current of internal reference voltage.
Table 24. Peripheral current consumption
(1)
(continued)
Peripheral
Typical consumption, V
DD
= 3.0 V, T
A
= 25 °C
Unit
Range 1,
V
CORE
=1.8 V
VOS[1:0] = 01
Range 2,
V
CORE
=1.5 V
VOS[1:0] = 10
Range 3,
V
CORE
=1.2 V
VOS[1:0] = 11
Low power
sleep and run