Datasheet

Revision history STM32F103xF, STM32F103xG
118/120 Doc ID 16554 Rev 3
8 Revision history
Table 74. Document revision history
Date Revision Changes
27-Oct-2009 1 Initial release.
15-Nov-2010 2
LQFP64 package mechanical data updated: see Figure 66: LQFP64 –
10 x 10 mm 64 pin low-profile quad flat package outline and Ta ble 71:
LQFP64 – 10 x 10 mm 64 pin low-profile quad flat package mechanical
data.
Internal code removed from Table 73: STM32F103xF and
STM32F103xG ordering information scheme.
Updated note 2 below Table 54: I
2
C characteristics
Updated Figure 46: I
2
C bus AC waveforms and measurement circuit
Updated Figure 45: Recommended NRST pin protection
Updated note 1 below Table 49: I/O static characteristics
Updated Table 20: Peripheral current consumption
Updated Table 14: Maximum current consumption in Run mode, code
with data processing
running from Flash
Updated Table 15: Maximum current consumption in Run mode, code
with data processing
running from RAM
Updated Table 16: Maximum current consumption in Sleep mode, code
running from Flash or RAM
Updated Table 17: Typical and maximum current consumptions in Stop
and Standby modes
Updated Table 18: Typical current consumption in Run mode, code with
data processing
running from Flash
Updated Table 19: Typical current consumption in Sleep mode, code
running from Flash or
RAM
Updated Table 24: LSE oscillator characteristics (f
LSE
= 32.768 kHz)
Updated Figure 22: Asynchronous non-multiplexed
SRAM/PSRAM/NOR read waveforms on page 62
Added Section 5.3.13: I/O current injection characteristics on page 83
18-Jan-2012 3
Section 2.3.26: GPIOs (general-purpose inputs/outputs): modified text
of last sentence.
Table 5: STM32F103xF and STM32F103xG pin definitions: updated
pins PD0, PD1, OSC_IN, OSC_OUT, PB8, PB9, and PF8.
Table 7: Voltage characteristics: Removed the previous footnotes 2 and
3 and added current footnote 2.
Table 8: Current characteristics: updated footnotes 3, 4, and 5.
Table 21: High-speed external user clock characteristics: replaced the
t
w(HSE)
min value by 5 (instead of 16).
Table 24: LSE oscillator characteristics (f
LSE
= 32.768 kHz): updated
symbols and footnotes.