Datasheet
STM32F101x4, STM32F101x6 Electrical characteristics
Doc ID 15058 Rev 5 31/79
5.3.2 Operating conditions at power-up / power-down
Subject to general operating conditions for T
A
.
Table 9. Operating conditions at power-up / power-down
5.3.3 Embedded reset and power control block characteristics
The parameters given in Tabl e 1 0 are derived from tests performed under the ambient
temperature and V
DD
supply voltage conditions summarized in Table 8.
P
D
Power dissipation at T
A
=
85 °C
(3)
LQFP64 444
mWLQFP48 363
VFQFPN36 1000
T
A Ambient temperature
Maximum power dissipation –40 85 °C
Low power dissipation
(4)
–40 105 °C
T
J Junction temperature range –40 105 °C
1. When the ADC is used, refer to Table 42: ADC characteristics.
2. It is recommended to power V
DD
and V
DDA
from the same source. A maximum difference of 300 mV
between V
DD
and V
DDA
can be tolerated during power-up and operation.
3. If T
A
is lower, higher P
D
values are allowed as long as T
J
does not exceed T
J
max (see Table 6.2: Thermal
characteristics on page 74).
4. In low power dissipation state, T
A
can be extended to this range as long as T
J
does not exceed T
J
max (see
Table 6.2: Thermal characteristics on page 74).
Table 8. General operating conditions (continued)
Symbol Parameter Conditions Min Max Unit
Symbol Parameter Conditions Min Max Unit
t
VDD
V
DD
rise time rate 0
∞
µs/V
V
DD
fall time rate 20
∞