Datasheet

Electrical characteristics STM32F100xC, STM32F100xD, STM32F100xE
78/98 Doc ID 15081 Rev 7
SPI interface characteristics
Unless otherwise specified, the parameters given in Ta bl e 5 0 are preliminary values derived
from tests performed under the ambient temperature, f
PCLKx
frequency and V
DD
supply
voltage conditions summarized in Ta bl e 9.
Refer to Section 5.3.13: I/O current injection characteristics for more details on the
input/output alternate function characteristics (NSS, SCK, MOSI, MISO).
Table 50. SPI characteristics
Symbol Parameter Conditions Min Max Unit
f
SCK
1/t
c(SCK)
SPI clock frequency
Master mode 12
MHz
Slave mode 12
t
r(SCK)
t
f(SCK)
SPI clock rise and fall
time
Capacitive load: C = 30 pF 8 ns
DuCy(SCK)
SPI slave input clock
duty cycle
Slave mode 30 70 %
t
su(NSS)
(1)
1. Preliminary values.
NSS setup time Slave mode 4t
PCLK
ns
t
h(NSS)
(1)
NSS hold time Slave mode 2t
PCLK
t
w(SCKH)
(1)
t
w(SCKL)
(1)
SCK high and low time
Master mode, f
PCLK
= 24 MHz,
presc = 4
50 60
t
su(MI)
(1)
t
su(SI)
(1)
Data input setup time
Master mode 5
Slave mode 5
t
h(MI)
(1)
Data input hold time
Master mode 5
t
h(SI)
(1)
Slave mode 4
t
a(SO)
(1)(2)
2. Min time is for the minimum time to drive the output and the max time is for the maximum time to validate
the data.
Data output access time Slave mode, f
PCLK
= 24 MHz 0 3t
PCLK
t
dis(SO)
(1)(3)
3. Min time is for the minimum time to invalidate the output and the max time is for the maximum time to put
the data in Hi-Z
Data output disable time Slave mode 2 10
t
v(SO)
(1)
Data output valid time Slave mode (after enable edge) 25
t
v(MO)
(1)
Data output valid time
Master mode (after enable
edge)
5
t
h(SO)
(1)
Data output hold time
Slave mode (after enable edge) 15
t
h(MO)
(1)
Master mode (after enable
edge)
2