Datasheet

Electrical characteristics STM32F100xC, STM32F100xD, STM32F100xE
36/98 Doc ID 15081 Rev 7
5.1.7 Current consumption measurement
Figure 10. Current consumption measurement scheme
5.2 Absolute maximum ratings
Stresses above the absolute maximum ratings listed in Table 6: Voltage characteristics,
Table 7: Current characteristics, and Table 8: Thermal characteristics may cause permanent
damage to the device. These are stress ratings only and functional operation of the device
at these conditions is not implied. Exposure to maximum rating conditions for extended
periods may affect device reliability.
ai14126
V
BAT
V
DD
V
DDA
I
DD
_V
BAT
I
DD
Table 6. Voltage characteristics
Symbol Ratings Min Max Unit
V
DD
− V
SS
External main supply voltage (including
V
DDA
and V
DD
)
(1)
1. All main power (V
DD
, V
DDA
) and ground (V
SS
, V
SSA
) pins must always be connected to the external power
supply, in the permitted range.
–0.3 4.0
V
V
IN
(2)
2. V
IN
maximum must always be respected. Refer to Table 7: Current characteristics for the maximum
allowed injected current values.
Input voltage on five volt tolerant pin V
SS
− 0.3 V
DD
+ 4.0
Input voltage on any other pin V
SS
− 0.3 4.0
|ΔV
DDx
| Variations between different V
DD
power pins 50
mV
|V
SSX
− V
SS
|
Variations between all the different ground
pins
50
V
ESD(HBM)
Electrostatic discharge voltage (human body
model)
see Section 5.3.12: Absolute
maximum ratings (electrical
sensitivity)