User manual

DocID025326 Rev 1 7/18
UM1677 Binary images for reprogramming firmware applications
17
3 Binary images for reprogramming firmware
applications
This section describes how to use the provided binary images to reprogram the firmware
applications. The STM32F030 Discovery firmware package contains binary images (*.hex)
of the provided applications under Binary subfolder. You can use any in-system
programming tool to reprogram the demonstration using this binary image.
to reprogram the firmware applications, use the “in-system programming tool” and:
1. Connect the STM32F030 Discovery board to a PC with a 'USB type A to Mini-B' cable
through USB connector CN1 to power the board.
2. Make sure that the embedded ST-LINK/V2 is configured for in-system programming
(both CN3 jumpers ON).
3. Use *.hex binary (for example,
\Project\Demonstration\Binary\STM32F0308-Discovery_Demonstration_V1.0.0.hex)
with your preferred in-system programming tool to reprogram the demonstration
firmware (ex. STM32 ST-LINK Utility, available for download from www.st.com).