Datasheet

Getting started UM1539
8/46 Doc ID 023106 Rev 1
Figure 3. Logic level and position of switch for address selection
1.2.5 Address configuration for STTS75, STDS75, STLM75 and STCN75
temperature sensors
The STTS75, STDS75, STLM75 and STCN75 all are digital temperature sensors with 3
address lines. There are 8 possible addresses for these sensors. SW2 corresponds to A0,
SW3 corresponds to A1 and SW4 corresponds to A2 address lines of the sensors. Below
are the allowed addresses and their settings for STTS75, STDS75, STLM75 and STCN75:
● Address 1 = 0x90, => SW4 = 0, SW3 = 0, SW2 = 0
● Address 2 = 0x92, => SW4 = 0, SW3 = 0, SW2 = 1
● Address 3 = 0x94, => SW4 = 0, SW3 = 1, SW2 = 0
● Address 4 = 0x96, => SW4 = 0, SW3 = 1, SW2 = 1
● Address 5 = 0x98, => SW4 = 1, SW3 = 0, SW2 = 0
● Address 6 = 0x9A, => SW4 = 1, SW3 = 0, SW2 = 1
● Address 7 = 0x9C, => SW4 = 1, SW3 = 1, SW2 = 0
● Address 8 = 0x9E, => SW4 = 1, SW3 = 1, SW2 = 1
!-V
3WITCHPOSITIONFORADDRESSLINES
,OGICLEVELAT
ADDRESSLINES
,/7 
LOGIC
()'( 
LOGIC


Table 2. Switch settings for selecting different addresses of STT75/STLM75/STDS75/STCN75
onboard
Address
line
Address
(0x9E)
Address
(0x9C)
Address
(0x9A)
Address
(0x98)
Address
(0x96)
Address
(0x94)
Address
(0x92)
Address
(0x90)
SW2 (A0)
SW3 (A1)
SW4 (A2)