Datasheet

Getting started UM1539
6/46 Doc ID 023106 Rev 1
1 Getting started
1.1 Package
The contents of the complete package are as follows:
1. Hardware content:
– Demonstration board: STEVAL-IFS017V1
2. Documentation:
– User manual (this document)
– Schematics, Gerber files, BOM
3. Firmware:
– Already programmed STM32F102xx device soldered on the demo board
4. GUI installation file.
1.2 System setup
The steps for starting the demo board are as follows:
1. Install the GUI .exe in the computer. The user should have administrator rights for the
computer to install the GUI.
2. Connect the USB cable between the computer and USB connector on the STEVAL-
IFS017V1 (CN4).
3. LED D3 should glow on the motherboard.
4. Opening the GUI shows the connected status in the bottom left corner of the window.
The daughter card power selection and feature demonstration is discussed in the following
sections.
Figure 2. Temperature sensor GUI connected
AM12155v1
GUI selection button