Datasheet

STEVAL-IFP019V1 Connectors
Doc ID 022565 Rev 1 3/5
2 Connectors
The STEVAL-IFP019V1 demonstration board uses input header connectors; one screw
drives the four-channel output connector and one screw drives the two-channel supply
connector.
Both input connectors, J5 and J1, provide the same bi-directional demonstration board
signalization guaranteeing maximum compatibility with existing ST tools.
Figure 2. J1 connector pinout
Figure 3. J5 connector pinout
Table 1. Connector J1 and J5 pinout mapping
J1 pin number J5 pin number Signal Type
11 1 V
dd
5 / 3.3 V supply voltage
23 2 GND Signal ground
9 3 IN1 Input channel 1
13 4 IN2 Input channel 2
15 5 IN3 Input channel 3
17 6 IN4 Input channel 4
6 7 STAT1 Status channel 1
25 8 STAT2 Status channel 2
21 9 STAT3 Status channel 3
19 10 STAT4 Status channel 4
!-V




!-V



