Datasheet

STDS75 Functional description
Doc ID 13297 Rev 9 25/38
3.6 WRITE mode
In this mode the master transmitter transmits to the STDS75 slave receiver. Bus protocol is
shown in Figure 12. Following the START condition and slave address, a logic '0' (R/W
= 0)
is placed on the bus and indicates to the addressed device that word address will follow and
is to be written to the on-chip address pointer.
These modes are shown in the WRITE mode typical timing diagrams (see Figure 12, and
Figure 13, and Figure 14 on page 26).
Figure 12. Typical pointer set followed by an Immediate READ from the
configuration register
Figure 13. Configuration register WRITE
AI12279b
1919
Repeat
Start
by
Master
ACK
by
STDS75
No ACK
by
STDS75
Stop
Cond.
by
Master
1 0 0 1 A2 A1 A0 D7 D6 D5 D4 D3 D2 D1 D0
R/W
Address Byte Data Byte
1199
1
Start
by
Master
Address Byte
Pointer Byte
ACK
by
STDS75
ACK
by
STDS75
001A2A1A0W 000000D1D0
AI12280b
119919
1
Start
by
Master
Address Byte
Pointer Byte
ACK
by
STDS75
ACK
by
STDS75
ACK
by
STDS75
Stop
Cond.
by
Master
001A2A1A0W 000000 000D4D3D2D1D0D1 D0
Configuration Byte