Datasheet
Table Of Contents
- Table 1. Device summary
- 1 Application circuit
- 2 Pin configuration
- 3 Maximum ratings
- 4 Electrical characteristics
- 5 Application information
- 5.1 Description
- 5.2 External components selection
- 5.3 Output capacitor (VOUT > 2.5 V)
- 5.4 Output capacitor (0.8 V < VOUT < 2.5 V)
- 5.5 Output voltage selection
- 5.6 Inductor (VOUT > 2.5 V)
- 5.7 Inductor (0.8 V < VOUT < 2.5 V)
- 5.8 Function operation
- 6 Layout considerations
- 7 Diagram
- 8 Typical performance characteristics
- Figure 9. Voltage feedback vs. temperature
- Figure 10. Oscillator frequency vs. temperature
- Figure 11. Max duty cycle vs. temperature
- Figure 12. Inhibit threshold vs. temperature
- Figure 13. Reference line regulation vs. temperature
- Figure 14. Reference load regulation vs. temperature
- Figure 15. ON mode quiescent current vs. temperature
- Figure 16. Shutdown mode quiescent current vs. temperature
- Figure 17. PMOS ON resistance vs. temperature
- Figure 18. NMOS ON resistance vs. temperature
- Figure 19. Efficiency vs. temperature
- Figure 20. Efficiency vs. output current@Vout = 5 V
- Figure 21. Efficiency vs. output current@Vout = 3.3 V
- Figure 22. Efficiency vs. output current@Vout = 12 V
- 9 Package mechanical data
- Table 6. Power SO-8 (exposed pad) mechanical data
- Figure 23. Power SO-8 (exposed pad) dimensions
- Figure 24. Power SO-8 (exposed pad) recommended footprint
- Table 7. Power SO-8 (exposed pad) tape and reel mechanical data
- Figure 25. Power SO-8 (exposed pad) tape and reel dimensions
- Table 8. DFN8 (4X4) mechanical data
- Figure 26. DFN8 (4x4) dimensions
- Table 9. DFN8 (4x4)tape and reel mechanical data
- Figure 27. DFN8 (4x4)tape and reel dimensions
- 10 Revision history

ST1S10 Electrical characteristics
Doc ID 13844 Rev 5 9/29
V
IH_SYNC
SYNC input threshold high V
IN
= 2.5 V to 18 V 1.6 V
I
IL,
I
IH
SYNC input current
V
IN
= 2.5 V to 18 V, V
SYNC
=
0 or 5 V
-10 +10 µA
UVLO Under voltage lock-out threshold
V
IN
rising 2.3 V
Hysteresis 200 mV
1. Guaranteed by design, but not tested in production.
2. See output voltage selection paragraph 5.5 for maximum duty cycle conditions.
Table 5. Electrical characteristics (continued)
Symbol Parameter Test conditions Min. Typ. Max. Unit