User's Manual

ManualsBrandsSTMicroelectronics ManualsElectronicsNFC card reader evaluation board

UM235x-1 Federal Communications Commission (FCC) and Industry Canada (IC) compliance

Federal Communications Commission (FCC) and

Industry Canada (IC) compliance statements

7.1

FCC Compliance Statement

7.1.1

Part 15.19

This device complies with Part 15 of the FCC Rules. Operation is subject to the following

two conditions:

(1) this device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that may cause

undesired operation.

NOTE: The grantee is not responsible for any changes or modifications not expressly

approved by the party responsible for compliance. Such modifications could void the user’s

authority to operate the equipment

7.1.2

7.1.3

Part 15.21

Any changes or modifications to this equipment not expressly approved by

STMicroelectronics may cause harmful interference and void the user ’s authority to operate

this equipment.

FCC ID

FCC ID: YCPR3916BD1

7.2

Formal notices required by the Industry Canada (“IC”)

7.2.1

Compliance Statement

7.2.2

7.2.3

Declaration de Conformité

L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux

CNR d’Innovation, Sciences et Développement économique Canada applicables aux

appareils radio exempts de licence. L’exploitation est autorisée aux deux conditions

suivantes :

1) L’appareil ne doit pas produire de brouillage ;

2) L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est

susceptible d’en compromettre le fonctionnement

IC ID

IC ID: 8976A-R3916BD1

UM235x Rev 02

29/31

This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation,

Science and Economic Development Canada’s licence-exempt RSS(s). Operation is subject

to the following two conditions:

(1) This device may not cause interference.

(2) This device must accept any interference, including interference that may cause

undesired operation of the device.

NOTE: The grantee is not responsible for any changes or modifications not expressly approved by the party

responsible for compliance. Such modifications could void the user’s authority to operate the equipment.