User manual

DocID025833 Rev 3 9/49

UM1724 Features

4 Features

The STM32 Nucleo boards offer the following features:

 STM32 microcontroller with LQFP64 package

 Two types of extension resources

– Arduino Uno Revision 3 connectivity

– STMicroelectronics Morpho extension pin headers for full access to all STM32 I/Os

 mbed-enabled

(a)

 On-board ST-LINK/V2-1 debugger/programmer with SWD connector

– selection-mode switch to use the kit as a standalone ST-LINK/V2-1

 Flexible board power supply

– USB VBUS

– External VIN (7V<VIN<12V) supply voltage from Arduino connectors or ST

Morpho connector

– External 5V (E5V) supply voltage from ST Morpho connector

– External +3.3V supply voltage from Arduino connector or ST Morpho connector

 Three LEDs

– USB communication (LD1), user LED (LD2), power LED (LD3)

 Two push buttons: USER and RESET

 USB re-enumeration capability: three different interfaces supported on USB

– Virtual Com port

– Mass storage

– Debug port

 Comprehensive free software HAL library including a variety of software examples

 Supported by wide choice of Integrated Development Environments (IDEs) including IAR,

Keil, GCC-based IDEs

a. See http://mbed.org/