User's Manual
Table Of Contents
- Introduction
- 1 Features
- 2 Ordering information
- 3 Development environment
- 4 Conventions
- 5 Safety recommendations
- 6 Quick start
- 7 Hardware layout and configuration
- 8 NUCLEO-WB15CC board information
- 9 Federal Communication Commission (FCC)
- 10 Innovation, Science and Economic Development Canada (ISED) Compliance Statements
- 11 RED compliance statement
- Revision history
- Contents
- List of tables
- List of figures
7.6 Push-buttons
7.6.1 Description
NUCLEO-WB15CC provides two types of buttons:
• B1 USER1 pushbutton
• B2 USER2 pushbutton
• B3 USER3 pushbutton
• B4 reset pushbutton to reset the NUCLEO-WB15CC board.
Figure 13. Push-buttons location
7.6.2 Reset push-button
B4 is dedicated to the hardware reset of the NUCLEO-WB15CC board.
7.6.3 User push-buttons
There are three push‑buttons available for the user application. They are connected to PA0, PE4, and PA6. It is
possible to use them for GPIO reading or to wake up the device (only B1).
UM2823
Push-buttons
UM2823 - Rev 1
page 20/37