User's Manual
Table Of Contents
- Introduction
- 1 Features
- 2 Ordering information
- 3 Development environment
- 4 Conventions
- 5 Safety recommendations
- 6 Quick start
- 7 Hardware layout and configuration
- 8 NUCLEO-WB15CC board information
- 9 Federal Communication Commission (FCC)
- 10 Innovation, Science and Economic Development Canada (ISED) Compliance Statements
- 11 RED compliance statement
- Revision history
- Contents
- List of tables
- List of figures
7.1.4 Current measurement
As the device has low power features, it can be interesting to measure the current consumed by NUCLEO-
WB15CC. To easily do this measurement, there are two possibilities:
1. Measure the supply current of the SoC using an ammeter in place of the JP1 jumper. In this case, all
supply sources can be used except the AVDD coming from the ARDUINO
®
connector. Figure 8 shows the
configuration.
Figure 8. Current measurement with an ammeter
UM2823
Power supply
UM2823 - Rev 1
page 14/37