User's Manual
Table Of Contents
- 1 Features
- 2 Product marking
- 3 System requirements
- 4 Development toolchains
- 5 Demonstration software
- 6 Ordering information
- 7 Hardware layout and configuration
- 7.1 Nucleo-68 board
- Figure 2. Nucleo-68 hardware block diagram
- Figure 3. Nucleo-68 board (top view)
- Figure 4. Nucleo-68 board (bottom view)
- Figure 5. Nucleo-68 board mechanical drawing
- Figure 6. Nucleo-68 board schematics
- Figure 7. Nucleo-68 board schematics - RF part
- Figure 8. Nucleo-68 board schematics - Connectors
- Figure 9. Nucleo-68 board schematics - Power management
- Figure 10. Nucleo-68 board schematics - ST-Link/V2-1
- 7.2 USB dongle
- 7.3 Getting started
- 7.4 Embedded ST-LINK/V2-1
- 7.5 Power supply and selection
- 7.6 Programing/debugging when the power supply is not from USB ST-LINK (5V_ST_link)
- 7.7 OSC clock sources
- 7.8 Reset sources
- 7.9 Virtual COM port: LPUART/USART
- 7.10 LEDs
- 7.11 Push buttons
- 7.12 Current measurement
- 7.13 Jumper configuration
- 7.1 Nucleo-68 board
- 8 Connectors
- Appendix A Nucleo-68 and USB dongle MCU IO assignment
- 9 Federal Communications Commission (FCC) and Industry Canada (IC) compliance statements
- 10 Revision history
UM2435 Rev 2 9/48
UM2435 Ordering information
47
6 Ordering information
To order the Nucleo-68 board corresponding to the targeted STM32 MCU refer to Table 1.
The STM32WB55 codification is explained with an example in Table 2.
Table 1. Ordering information
Order code Target MCU
P-NUCLEO-WB55
STM32WB55RG (Nucleo-68)
STM32WB55CG (USB dongle)
Table 2. Example of codification
STM32WB55RG Description
STM32WB 32-bit microcontroller, based on Arm
®
Cortex
®
processor(s)
WB Wireless Bluetooth
®
and 802.15.4
55 Die 5, 1 Mbyte of Flash memory, 256 Kbytes of SRAM, full set of features
R Number of pins (R = 68)
G Memory size (G = 1 Mbyte)