User's Manual
Table Of Contents
- 1 Features
- 2 Product marking
- 3 System requirements
- 4 Development toolchains
- 5 Demonstration software
- 6 Ordering information
- 7 Hardware layout and configuration
- 7.1 Nucleo-68 board
- Figure 2. Nucleo-68 hardware block diagram
- Figure 3. Nucleo-68 board (top view)
- Figure 4. Nucleo-68 board (bottom view)
- Figure 5. Nucleo-68 board mechanical drawing
- Figure 6. Nucleo-68 board schematics
- Figure 7. Nucleo-68 board schematics - RF part
- Figure 8. Nucleo-68 board schematics - Connectors
- Figure 9. Nucleo-68 board schematics - Power management
- Figure 10. Nucleo-68 board schematics - ST-Link/V2-1
- 7.2 USB dongle
- 7.3 Getting started
- 7.4 Embedded ST-LINK/V2-1
- 7.5 Power supply and selection
- 7.6 Programing/debugging when the power supply is not from USB ST-LINK (5V_ST_link)
- 7.7 OSC clock sources
- 7.8 Reset sources
- 7.9 Virtual COM port: LPUART/USART
- 7.10 LEDs
- 7.11 Push buttons
- 7.12 Current measurement
- 7.13 Jumper configuration
- 7.1 Nucleo-68 board
- 8 Connectors
- Appendix A Nucleo-68 and USB dongle MCU IO assignment
- 9 Federal Communications Commission (FCC) and Industry Canada (IC) compliance statements
- 10 Revision history
UM2435
48/48 UM2435 Rev 2
IMPORTANT NOTICE – PLEASE READ CAREFULLY
STMicroelectronics NV and its subsidiaries (“ST”) reserve the right to make changes, corrections, enhancements, modifications, and
improvements to ST products and/or to this document at any time without notice. Purchasers should obtain the latest relevant information on
ST products before placing orders. ST products are sold pursuant to ST’s terms and conditions of sale in place at the time of order
acknowledgement.
Purchasers are solely responsible for the choice, selection, and use of ST products and ST assumes no liability for application assistance or
the design of Purchasers’ products.
No license, express or implied, to any intellectual property right is granted by ST herein.
Resale of ST products with provisions different from the information set forth herein shall void any warranty granted by ST for such product.
ST and the ST logo are trademarks of ST. All other product or service names are the property of their respective owners.
Information in this document supersedes and replaces information previously supplied in any prior versions of this document.
© 2019 STMicroelectronics – All rights reserved