User's Manual
Table Of Contents
- 1 Features
- 2 Ordering information
- 3 Development environment
- 4 Conventions
- 5 Delivery recommendations
- 6 Hardware layout and configuration
- 6.1 Power supply management
- 6.2 Clocks
- 6.3 Reset sources
- 6.4 User buttons and LEDs
- 6.5 Physical input devices: buttons
- 6.6 Boot options
- 6.7 Embedded ST-LINK/V2-1
- 6.8 ETM TRACE Mictor-38 connector
- 6.9 JTAG connector
- 6.10 DDR3L
- 6.11 eMMC
- 6.12 NAND Flash memory
- 6.13 Quad-SPI NOR Flash memory
- 6.14 microSD card
- 6.15 Audio
- 6.16 DSI LCD
- 6.17 Camera
- 6.18 1 Gbps Ethernet
- 6.19 USB OTG HS
- 6.20 USB host
- 6.21 RS-232 port
- 6.22 CAN FD
- 6.23 Smartcard
- 6.24 ADC/DAC
- 6.25 I2C_EXT connector
- 6.26 MFX MCU
- 6.27 Motor control
- 6.28 GPIO 40-pin expansion connector
- 6.29 RGB LTDC connector
- 7 STM32MP157F-EV1 Evaluation board information
- Appendix B STM32MP157F-EV1 I/O assignment
- Appendix C Federal Communications Commission (FCC) and ISED Canada Compliance Statements
- Appendix D CE conformity
- Revision history
- Contents
- List of tables
- List of figures
5 Delivery recommendations
Before the first use, make sure that no damage occurred to the board during shipment and no socketed
components are loose in their sockets or fallen into the plastic bag.
In particular
, pay attention to the following components:
1. MB1263 daughterboard connected to the MB1262 mother board
2. microSD card in its MB1263/CN9 receptacle
3. LCD MB1230 daughterboard in MB1262/CN19 DSI connector, and screw, spacer and nut are in place
4. Camera module MB1379 board in MB1262/CN7 connector, and screw, spacer and nut are in place
For product information related to the STM32MP157 microprocessors, visit the www.st.com website.
UM2648
Delivery recommendations
UM2648 - Rev 1
page 6/61