Datasheet

Power-up and delivery state M95M01-DF M95M01-R
30/45 Doc ID 13264 Rev 11
7 Power-up and delivery state
7.1 Power-up state
After power-up, the device is in the following state:
● Standby power mode,
● deselected (after power-up, a falling edge is required on Chip Select (S) before any
instructions can be started),
● not in the Hold condition,
● the Write Enable Latch (WEL) is reset to 0,
● Write In Progress (WIP) is reset to 0.
The SRWD, BP1 and BP0 bits of the Status Register are unchanged from the previous
power-down (they are non-volatile bits).
7.2 Initial delivery state
The device is delivered with the memory array set to all 1s (each byte = FFh). The Status
Register Write Disable (SRWD) and Block Protect (BP1 and BP0) bits are initialized to 0.