Datasheet

M95M01-DF M95M01-R Instructions
Doc ID 13264 Rev 11 27/45
6.8 Write Identification Page (available only in M95M01-D
devices)
The Identification Page (256 bytes) is an additional page which can be written and (later)
permanently locked in Read-only mode.
Writing this page is achieved with the Write Identification Page instruction (see Table 4). The
Chip Select signal (S
) is first driven low. The bits of the instruction byte, address bytes, and
at least one data byte are then shifted in on Serial Data Input (D). Address bit A10 must be
0, upper address bits are Don't Care, the lower address bits [A7:A0] address bits define the
byte address inside the identification page. The instruction sequence is shown in Figure 16.
Figure 16. Write identification page sequence
MS30909V1
C
D
S
Q
23
21 3 4 5 6 7 8 9 10 28 29 30 31 32 33 34 35
22 21 3 2 1 0
36 37 38
High impedance
Instruction 24-bit address
0
765432 0
1
Data byte
39