Datasheet

Power-up and delivery state M95320-W M95320-R M95320-DF
30/46 Doc ID 5711 Rev 15
7 Power-up and delivery state
7.1 Power-up state
After power-up, the device is in the following state:
● Standby power mode,
● deselected (after power-up, a falling edge is required on Chip Select (S) before any
instructions can be started),
● not in the Hold condition,
● the Write Enable Latch (WEL) is reset to 0,
● Write In Progress (WIP) is reset to 0.
The SRWD, BP1 and BP0 bits of the Status Register are unchanged from the previous
power-down (they are non-volatile bits).
7.2 Initial delivery state
The device is delivered with all the memory array bits and Identification page bits set to 1
(each byte contains FFh).