Datasheet

DocID5124 Rev 6 21/37

M93S46-W M93S56-W M93S66-W Instructions

and Write Enable (W) signals must be driven High during the instruction execution. The

OTP bit cannot be directly read, it can be checked by reading the content of the Protection

same value back into the Protection Register, using the Protection Register Write

(PRWRITE) instruction.

When the OTP bit is set, the Ready/Busy status cannot appear on Serial Data Output (Q).

When the OTP bit is not set, the Busy status appears on Serial Data Output (Q).

Note: A Protection Register Enable (PREN) instruction must immediately precede the Protection