Datasheet
Table Of Contents
- 1 Description
- 2 Operation
- 3 Clock operation
- 4 Maximum ratings
- 5 DC and AC parameters
- Table 5. Operating and AC measurement conditions
- Figure 14. AC testing input/output waveform
- Table 6. Capacitance
- Table 7. DC characteristics
- Table 8. Crystal electrical characteristics
- Figure 15. Power down/up mode AC waveforms
- Table 9. Power down/up AC characteristics
- Table 10. Power down/up trip points DC characteristics
- 6 Package mechanical data
- Figure 16. SO8 - 8-lead plastic small outline package outline
- Table 11. SO8 - 8-lead plastic small outline (150 mils body width) package mechanical data
- Figure 17. SOH28 - 28-lead plastic small outline, battery SNAPHAT® package outline
- Table 12. SOH28 - 28-lead plastic small outline, battery SNAPHAT® package mechanical data
- Figure 18. SH - 4-pin SNAPHAT® housing for 48 mAh battery & crystal package outline
- Table 13. SH - 4-pin SNAPHAT® housing for 48 mAh battery & crystal, package mechanical data
- Figure 19. SH - 4-pin SNAPHAT® housing for 120 mAh battery & crystal, package outline
- Table 14. SH - 4-pin SNAPHAT® housing for 120 mAh battery & crystal, package mech. data
- 7 Part numbering
- 8 Environmental information
- 9 Revision history
Maximum ratings M41T11
18/30 Doc ID 6103 Rev 10
4 Maximum ratings
Stressing the device above the rating listed in the absolute maximum ratings table may
cause permanent damage to the device. These are stress ratings only and operation of the
device at these or any other conditions above those indicated in the operating sections of
this specification is not implied. Exposure to absolute maximum rating conditions for
extended periods may affect device reliability.
Caution: Negative undershoots below –0.3 V are not allowed on any pin while in the battery backup
mode.
Caution: Do NOT wave solder SOIC to avoid damaging SNAPHAT
®
sockets.
Table 4. Absolute maximum ratings
Symbol Parameter Value Unit
T
A
Ambient operating temperature –40 to 85 °C
T
STG
Storage temperature (V
CC
off, oscillator off)
SNAPHAT
®
–40 to 85
°C
SOIC –55 to 125
T
SLD
(1)
1. Lead-free (Pb-free) lead finish: reflow at peak temperature of 260°C (the time above 255°C must not
exceed 30 seconds).
Lead solder temperature for 10 seconds 260 °C
V
IO
Input or output voltages –0.3 to 7 V
V
CC
Supply voltage –0.3 to 7 V
I
O
Output current 20 mA
P
D
Power dissipation 0.25 W