Datasheet

Instructions M24C32-W M24C32-R M24C32-F M24C32-X M24C32-DF
20/40 Doc ID 4578 Rev 21
5.2 Read operations
Read operations are performed independently of the state of the Write Control (WC) signal.
After the successful completion of a Read operation, the device’s internal address counter is
incremented by one, to point to the next byte address.
For the Read instructions, after each byte read (data out), the device waits for an
acknowledgment (data in) during the 9th bit time. If the bus master does not acknowledge
during this 9th time, the device terminates the data transfer and switches to its Standby
mode.
Figure 9. Read mode sequences
5.2.1 Random Address Read
A dummy Write is first performed to load the address into this address counter (as shown in
Figure 9) but without sending a Stop condition. Then, the bus master sends another Start
condition, and repeats the device select code, with the RW
bit set to 1. The device
acknowledges this, and outputs the contents of the addressed byte. The bus master must
not acknowledge the byte, and terminates the transfer with a Stop condition.
Start
Dev sel * Byte addr Byte addr
Start
Dev sel Data out 1
AI01105d
Data out N
Stop
Start
Current
Address
Read
Dev sel Data out
Random
Address
Read
Stop
Start
Dev sel * Data out
Sequential
Current
Read
Stop
Data out N
Start
Dev sel * Byte addr Byte addr
Sequention
Random
Read
Start
Dev sel * Data out1
Stop
ACK
R/W
NO ACK
ACK
R/W
ACK ACK ACK
R/W
ACK ACK ACK NO ACK
R/W
NO ACK
ACK ACK ACK
R/W
ACK ACK
R/W
ACK NO ACK