Datasheet

Instructions M24C08-W M24C08-R M24C08-F
18/40 DocID023924 Rev 3
5.2 Read operations
Read operations are performed independently of the state of the Write Control (WC) signal.
After the successful completion of a Read operation, the device internal address counter is
incremented by one, to point to the next byte address.
For the Read instructions, after each byte read (data out), the device waits for an
acknowledgment (data in) during the 9th bit time. If the bus master does not acknowledge
during this 9th time, the device terminates the data transfer and switches to its Standby
mode.
Figure 10. Read mode sequences
3TART
$EVSELECT "YTEADDRESS
3TART
$EVSELECT $ATAOUT
!)B
$ATAOUT.
3TOP
3TART
#URRENT
!DDRESS
2EAD
$EVSELECT $ATAOUT
2ANDOM
!DDRESS
2EAD
3TOP
3TART
$EVSELECT $ATAOUT
3EQUENTIAL
#URRENT
2EAD
3TOP
$ATAOUT.
3TART
$EVSELECT "YTEADDRESS
3EQUENTIAL
2ANDOM
2EAD
3TART
$EVSELECT $ATAOUT
3TOP
!#+
27
./!#+
!#+
27
!#+
!#+
27
!#+ !#+ !#+ ./!#+
27
./!#+
!#+ !#+
27
!#+ !#+
27
!#+ ./!#+