Datasheet
Table Of Contents
- 1 Description
- 2 Signal description
- 3 Memory organization
- 4 Device operation
- 5 Instructions
- 6 Initial delivery state
- 7 Maximum rating
- 8 DC and AC parameters
- Table 5. Operating conditions (voltage range W)
- Table 6. Operating conditions (voltage range R)
- Table 7. Operating conditions (voltage range F, for devices identified by process letter T)
- Table 8. Operating conditions (voltage range F, for all other devices)
- Table 9. AC measurement conditions
- Figure 11. AC measurement I/O waveform
- Table 10. Input parameters
- Table 11. Cycling performance
- Table 12. Memory cell data retention
- Table 13. DC characteristics (M24C08-W, device grade 6)
- Table 14. DC characteristics (M24C08-R, device grade 6)
- Table 15. DC characteristics (M24C08-F device)
- Table 16. 400 kHz AC characteristics
- Table 17. 100 kHz AC characteristics (I2C Standard mode)
- Figure 12. Maximum Rbus value versus bus parasitic capacitance (Cbus) for an I2C bus at maximum frequency fC = 400 kHz
- Figure 13. AC waveforms
- 9 Package mechanical data
- Figure 14. TSSOP8 – 8-lead thin shrink small outline, package outline
- Table 18. TSSOP8 – 8-lead thin shrink small outline, package mechanical data
- Figure 15. SO8N – 8-lead plastic small outline, 150 mils body width, package outline
- Table 19. SO8N – 8-lead plastic small outline, 150 mils body width, package data
- Figure 16. PDIP8 – 8-pin plastic DIP, 0.25 mm lead frame, package outline
- Table 20. PDIP8 – 8-pin plastic DIP, 0.25 mm lead frame, package mechanical data
- Figure 17. UFDFPN8 (MLP8) – package outline (UFDFPN: Ultra thin Fine pitch Dual Flat Package, No lead)
- Table 21. UFDFPN8 (MLP8) – package dimensions (UFDFPN: Ultra thin Fine pitch Dual Flat Package, No lead)
- Figure 18. M24C08-FCS5TP/S WLCSP package outline
- Table 22. M24C08-FCS5TP/S WLCSP package data
- Figure 19. Thin M24C08-FCT5TP/S WLCSP package outline
- Table 23. Thin M24C08-FCT5TP/S WLCSP package data
- 10 Part numbering
- 11 Revision history

DocID023924 Rev 3 11/40
M24C08-W M24C08-R M24C08-F Device operation
39
4 Device operation
The device supports the I
2
C protocol. This is summarized in Figure 6. Any device that sends
data on to the bus is defined to be a transmitter, and any device that reads the data to be a
receiver. The device that controls the data transfer is known as the bus master, and the
other as the slave device. A data transfer can only be initiated by the bus master, which will
also provide the serial clock for synchronization. The device is always a slave in all
communications.
Figure 6. I
2
C bus protocol
3#,
3$!
3#,
3$!
3$!
34!24
#ONDITION
3$!
)NPUT
3$!
#HANGE
!)"
34/0
#ONDITION
-3"
!#+
34!24
#ONDITION
3#,
-3" !#+
34/0
#ONDITION