Datasheet

Absolute maximum ratings LM158, LM258, LM358
4/22 DocID2163 Rev 11
2 Absolute maximum ratings
Table 1. Absolute maximum ratings
Symbol Parameter LM158,A LM258,A LM358,A Unit
V
CC
Supply voltage +/-16 or 32 V
V
i
Input voltage 32 V
V
id
Differential input voltage 32 V
Output short-circuit duration
(1)
1. Short-circuits from the output to V
CC
can cause excessive heating if V
CC
> 15 V. The maximum output
current is approximately 40 mA independent of the magnitude of V
CC
. Destructive dissipation can result
from simultaneous short circuits on all amplifiers.
Infinite
I
in
Input current
(2)
2. This input current only exists when the voltage at any of the input leads is driven negative. It is due to the
collector-base junction of the input PNP transistor becoming forward-biased and thereby acting as input
diode clamp. In addition to this diode action, there is NPN parasitic action on the IC chip. This transistor
action can cause the output voltages of the Op-amps to go to the V
CC
voltage level (or to ground for a large
overdrive) for the time during which an input is driven negative.
This is not destructive and normal output is restored for input voltages above -0.3 V.
5 mA in DC or 50 mA in AC (duty
cycle = 10%, T=1s)
mA
T
oper
Operating free-air temperature range -55 to +125 -40 to +105 0 to +70 °C
T
stg
Storage temperature range -65 to +150 °C
T
j
Maximum junction temperature 150 °C
R
thja
Thermal resistance junction to ambient
(3)
SO8
MiniSO8
TSSOP8
DIP8
DFN8 2x2
3. Short-circuits can cause excessive heating and destructive dissipation. R
th
are typical values.
125
190
120
85
57
°C/W
R
thjc
Thermal resistance junction to case
(3)
SO8
MiniSO8
TSSOP8
DIP8
40
39
37
41
°C/W
ESD
HBM: human body model
(4)
4. Human body model: a 100 pF capacitor is charged to the specified voltage, then discharged through a
1.5 kW resistor between two pins of the device. This is done for all couples of connected pin combinations
while the other pins are floating.
300 V
MM: machine model
(5)
5. Machine model: a 200 pF capacitor is charged to the specified voltage, then discharged directly between
two pins of the device with no external series resistor (internal resistor < 5 W). This is done for all couples
of connected pin combinations while the other pins are floating.
200 V
CDM: charged device model
(6)
6. Charged device model: all pins and the package are charged together to the specified voltage and then
discharged directly to the ground through only one pin. This is done for all pins.
1.5 kV