Datasheet
Table Of Contents
- 1 Absolute Maximum Ratings
- 2 Typical Application Information
- 3 Electrical Characteristics
- Table 2. VCC+ = 5V, Vcc- = Ground, Vo = 1.4V, Tamb = 25 C (unless otherwise specified)
- Figure 3. Input bias current vs. Tamb
- Figure 4. Input voltage range
- Figure 5. Current limiting
- Figure 6. Supply current
- Figure 7. Gain bandwidth product
- Figure 8. Voltage follower pulse response
- Figure 9. Common mode rejection ratio
- Figure 10. Output characteristics
- Figure 11. Open loop frequency response
- Figure 12. Voltage follower pulse response
- Figure 13. Large signal frequency response
- Figure 14. Output characteristics
- Figure 15. Positive supply voltage
- Figure 16. Positive supply voltage
- Figure 17. Power supply & common mode rejection ratio
- Figure 18. Large signal voltage gain
- 4 Typical Single-Supply Applications
- Figure 19. AC coupled inverting amplifier
- Figure 20. AC coupled non-inverting amplifier
- Figure 21. Non-inverting DC gain
- Figure 22. DC summing amplifier
- Figure 23. Active bandpass filter
- Figure 24. High input Z adjustable gain DC instrumentation amplifier
- Figure 25. High input Z, DC differential amplifier
- Figure 26. Low drift peak detector
- Figure 27. Using symmetrical amplifiers to reduce input current (general concept)
- 5 Package Mechanical Data
- 6 Revision History
Revision History LM2902
14/14
6 Revision History
Date Revision Changes
Nov. 2001 1 Initial release.
July 2005 2
1 - PPAP references inserted in the datasheet see
Table : Order Codes
on page 1
.
2 - ESD protection inserted in
Table 1 on page 2
.
Oct. 2005 3
The following changes were made in this revision:
– An error in the device description was corrected on page 1.
– PPAP reference inserted in the datasheet see
Table : Order Codes
on page 1
.
– Minor grammatical and formatting changes throughout.
Information furnished is believed to be accurate and reliable. However, STMicroelectronics assumes no responsibility for the consequences
of use of such information nor for any infringement of patents or other rights of third parties which may result from its use. No license is
granted by implication or otherwise under any patent or patent rights of STMicroelectronics. Specifications mentioned in this publication are
subject to change without notice. This publication supersedes and replaces all information previously supplied. STMicroelectronics products
are not authorized for use as critical components in life support devices or systems without express written approval of STMicroelectronics.
The ST logo is a registered trademark of STMicroelectronics.
All other names are the property of their respective owners
© 2005 STMicroelectronics - All rights reserved
STMicroelectronics group of companies
Australia - Belgium - Brazil - Canada - China - Czech Republic - Finland - France - Germany - Hong Kong - India - Israel - Italy - Japan -
Malaysia - Malta - Morocco - Singapore - Spain - Sweden - Switzerland - United Kingdom - United States of America
www.st.com