Datasheet
Table Of Contents
- 1 Absolute Maximum Ratings
- 2 Typical Application Information
- 3 Electrical Characteristics
- Table 2. VCC+ = 5V, Vcc- = Ground, Vo = 1.4V, Tamb = 25 C (unless otherwise specified)
- Figure 3. Input bias current vs. Tamb
- Figure 4. Input voltage range
- Figure 5. Current limiting
- Figure 6. Supply current
- Figure 7. Gain bandwidth product
- Figure 8. Voltage follower pulse response
- Figure 9. Common mode rejection ratio
- Figure 10. Output characteristics
- Figure 11. Open loop frequency response
- Figure 12. Voltage follower pulse response
- Figure 13. Large signal frequency response
- Figure 14. Output characteristics
- Figure 15. Positive supply voltage
- Figure 16. Positive supply voltage
- Figure 17. Power supply & common mode rejection ratio
- Figure 18. Large signal voltage gain
- 4 Typical Single-Supply Applications
- Figure 19. AC coupled inverting amplifier
- Figure 20. AC coupled non-inverting amplifier
- Figure 21. Non-inverting DC gain
- Figure 22. DC summing amplifier
- Figure 23. Active bandpass filter
- Figure 24. High input Z adjustable gain DC instrumentation amplifier
- Figure 25. High input Z, DC differential amplifier
- Figure 26. Low drift peak detector
- Figure 27. Using symmetrical amplifiers to reduce input current (general concept)
- 5 Package Mechanical Data
- 6 Revision History
LM2902 Package Mechanical Data
11/14
5 Package Mechanical Data
In order to meet environmental requirements, ST offers these devices in ECOPACK
®
packages.
These packages have a Lead-free second level interconnect. The category of second level
interconnect is marked on the package and on the inner box label, in compliance with JEDEC
Standard JESD97. The maximum ratings related to soldering conditions are also marked on
the inner box label. ECOPACK is an ST trademark. ECOPACK specifications are available at:
www.st.com
.
5.1 DIP14 package
DIM.
mm. inch
MIN. TYP MAX. MIN. TYP. MAX.
a1 0.51 0.020
B 1.39 1.65 0.055 0.065
b 0.5 0.020
b1 0.25 0.010
D 20 0.787
E 8.5 0.335
e 2.54 0.100
e3 15.24 0.600
F 7.1 0.280
I 5.1 0.201
L 3.3 0.130
Z 1.27 2.54 0.050 0.100
Plastic DIP-14 MECHANICAL DATA
P001A