Datasheet
LM158-LM258-LM358-LM158A-LM258A-LM358A Absolute Maximum Ratings
3/16
1 Absolute Maximum Ratings
Table 1. Key parameters and their absolute maximum ratings
Symbol Parameter LM158,A LM258,A LM358,A Unit
V
CC
Supply voltage +/-16 or 32 V
Vi Input Voltage -0.3 to +32 V
V
id
Differential Input Voltage +32 V
P
tot
Power Dissipation
(1)
1. Power dissipation must be considered to ensure maximum junction temperature (Tj) is not exceeded.
500 mW
Output Short-circuit Duration
(2)
2. Short-circuits from the output to V
CC
can cause excessive heating if V
CC
> 15V. The maximum output current
is approximately 40mA independent
of the magnitude of V
CC
. Destructive dissipation can result from simultaneous short-circuit on all amplifiers.
Infinite
I
in
Input Current
(3)
3. This input current only exists when the voltage at any of the input leads is driven negative. It is due to the
collector-base junction of the input PNP
transistor becoming forward biased and thereby acting as input diodes clamps. In addition to this diode action,
there is also NPN parasitic action on
the IC chip. this transistor action can cause the output voltages of the Op-amps to go to the V
CC
voltage level
(or to ground for a large overdrive)
for the time duration than an input is driven negative.
This is not destructive and normal output will set up again for input voltage higher than -0.3V.
50 mA
T
oper
Operating Free-air Temperature Range -55 to +125 -40 to +105 0 to +70 °C
T
stg
Storage Temperature Range -65 to +150 °C
T
j
Maximum Junction Temperature 150 °C
R
thja
Thermal Resistance Junction to Ambient
(4)
SO8
TSSOP8
DIP8
miniSO8
4. Short-circuits can cause excessive heating. Destructive dissipation can result from simultaneous short-circuit
on all amplifiers
125
120
85
190
°C/W
ESD
HBM: Human Body Model
(5)
5. Human body model, 100pF discharged through a 1.5kΩ resistor into pin of device.
300 V
MM: Machine Model
(6)
6. Machine model ESD, a 200pF cap is charged to the specified voltage, then discharged directly into the IC with
no external series resistor (internal resistor < 5Ω), into pin to pin of device.
200 V
CDM: Charged Device Model 1.5 kV